Search results
Results from the WOW.Com Content Network
In April 2010, the Wi-Fi Alliance announced the inclusion of additional EAP [30] types to its WPA- and WPA2-Enterprise certification programs. [31] This was to ensure that WPA-Enterprise certified products can interoperate with one another. As of 2010 the certification program includes the following EAP types: EAP-TLS (previously tested)
The WPA profile also provides optional support for the AES-CCMP algorithm that is the preferred algorithm in 802.11i and WPA2. WPA Enterprise provides RADIUS based authentication using 802.1X. WPA Personal uses a pre-shared Shared Key to establish the security using an 8 to 63 character passphrase. The PSK may also be entered as a 64 character ...
The Wi-Fi Alliance refers to their approved, interoperable implementation of the full 802.11i as WPA2, also called RSN (Robust Security Network). 802.11i makes use of the Advanced Encryption Standard (AES) block cipher, whereas WEP and WPA use the RC4 stream cipher.
TDLS, or Tunneled Direct Link Setup, is "a seamless way to stream media and other data faster between devices already on the same Wi-Fi network" based on IEEE 802.11z and added to Wi-Fi Alliance certification program in 2012. Devices using it communicate directly with one another, without involving the wireless network's router.
The more secure WPA2 using Advanced Encryption Standard was introduced in 2004 and is supported by most new Wi-Fi devices. WPA2 is fully compatible with WPA. [140] In 2017, a flaw in the WPA2 protocol was discovered, allowing a key replay attack, known as KRACK. [141] [142] A QR code to automate a Wi-Fi connection using WIFI:S:Wikipedia;T:WPA;P ...
WPA was an intermediate solution for hardware that could not support WPA2. Both WPA and WPA2 are much more secure than WEP. [21] To add support for WPA or WPA2, some old Wi-Fi access points might need to be replaced or have their firmware upgraded. WPA was designed as an interim software-implementable solution for WEP that could forestall ...
The Lightweight Extensible Authentication Protocol (LEAP) method was developed by Cisco Systems prior to the IEEE ratification of the 802.11i security standard. [3] Cisco distributed the protocol through the CCX (Cisco Certified Extensions) as part of getting 802.1X and dynamic WEP adoption into the industry in the absence of a standard.
The packet number is a 48-bit number stored across 6 octets. The PN codes are the first two and last four octets of the CCMP header and are incremented for each subsequent packet. Between the PN codes are a reserved octet and a Key ID octet. The Key ID octet contains the Ext IV (bit 5), Key ID (bits 6–7), and a reserved subfield (bits 0–4).