enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Noise-figure meter - Wikipedia

    en.wikipedia.org/wiki/Noise-figure_meter

    The noise current is set by the filament temperature. The current is an exponential function of filament temperature. At low frequencies, there is 1/f noise. At high frequencies, the transit time of the electron becomes an issue. Ott (1976, pp. 218–219) describes using a noise diode to measure noise factor.

  3. Audio system measurements - Wikipedia

    en.wikipedia.org/wiki/Audio_system_measurements

    The measure of the low frequency (many tens of Hz) noise contributed by the turntable of an analogue playback system. It is caused by imperfect bearings, uneven motor windings, vibrations in driving bands in some turntables, room vibrations (e.g., from traffic) that is transmitted by the turntable mounting and so to the phono cartridge.

  4. ITU-R 468 noise weighting - Wikipedia

    en.wikipedia.org/wiki/ITU-R_468_noise_weighting

    The human ear responds quite differently to clicks and bursts of random noise, and it is this difference that gave rise to the CCIR-468 weighting curve (now supported as an ITU standard), which together with quasi-peak measurement (rather than the rms measurement used with A-weighting) became widely used by broadcasters throughout Britain ...

  5. Audio noise measurement - Wikipedia

    en.wikipedia.org/wiki/Audio_noise_measurement

    Microphones, amplifiers and recording systems all add some electronic noise to the signals passing through them, generally described as hum, buzz or hiss. All buildings have low-level magnetic and electrostatic fields in and around them emanating from mains supply wiring, and these can induce hum into signal paths, typically 50 Hz or 60 Hz (depending on the country's electrical supply standard ...

  6. Signal-to-noise ratio - Wikipedia

    en.wikipedia.org/wiki/Signal-to-noise_ratio

    Signal-to-noise ratio (SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. SNR is defined as the ratio of signal power to noise power, often expressed in decibels. A ratio higher than 1:1 (greater than 0 dB) indicates more signal than noise.

  7. Noise floor - Wikipedia

    en.wikipedia.org/wiki/Noise_floor

    Measurement from a spectrum analyzer showing a noise-like measurement from an unspecified component.. In signal theory, the noise floor is the measure of the signal created from the sum of all the noise sources and unwanted signals within a measurement system, where noise is defined as any signal other than the one being monitored.

  8. Acoustical measurements and instrumentation - Wikipedia

    en.wikipedia.org/wiki/Acoustical_measurements...

    Dynamic range is a measure of how small you can measure a signal relative to the maximum input signal the device can measure. Expressed in decibels, the dynamic range is 20 log (Vmax/Vmin). For example, a device with an input range of ±10 V and a dynamic range of 110 dB will be able to measure a signal as small as 10 μV.

  9. Phase noise - Wikipedia

    en.wikipedia.org/wiki/Phase_noise

    Spectrum analyzer based measurement can show the phase-noise power over many decades of frequency; e.g., 1 Hz to 10 MHz. The slope with offset frequency in various offset frequency regions can provide clues as to the source of the noise; e.g., low frequency flicker noise decreasing at 30 dB per decade (= 9 dB per octave). [3]