Search results
Results from the WOW.Com Content Network
The output to input frequency ratio of a three-phase CCV must be less than about one-third for circulating current mode CCVs or one-half for blocking mode CCVs.(Lander 1993, p. 188) [3] Output waveform quality improves as the pulse number of switching-device bridges in phase-shifted configuration increases in CCV's input. In general, CCVs can ...
An American Rotary Phase Converter with a Transformer. A phase converter is a device that converts electric power provided as single phase to multiple phase or vice versa. The majority of phase converters are used to produce three-phase electric power from a single-phase source, thus allowing the operation of three-phase equipment at a site that only has single-phase electrical service.
A cycloconverter is also a type of frequency changer. Unlike a VFD, which is an indirect frequency changer since it uses an AC-DC stage and then a DC-AC stage, a cycloconverter is a direct frequency changer because it uses no intermediate stages. Another application is in the aerospace and airline industries. Often airplanes use 400 Hz power so ...
For example, balanced two-phase power can be obtained from a three-phase network by using two specially constructed transformers, with taps at 50% and 86.6% of the primary voltage. This Scott T connection produces a true two-phase system with 90° time difference between the phases.
The tap converter is a variation on the cycloconverter, invented in 1981 by New York City electrical engineer Melvin Sandler and significantly functionally enhanced in 1982 through 1984 by graduate students Mariusz Wrzesniewski, Bruce David Wilner, and Eddie Fung.
A cycloconverter operates as a three-phase current source via three anti-parallel-connected SCR-bridges in six-pulse configuration, each cycloconverter phase acting selectively to convert fixed line-frequency AC voltage to an alternating voltage at a variable load frequency. MC drives are IGBT-based.
Three-phase transformer with four-wire output for 208Y/120 volt service: one wire for neutral, others for A, B and C phases. Three-phase electric power (abbreviated 3ϕ [1]) is a common type of alternating current (AC) used in electricity generation, transmission, and distribution. [2]
One way to reduce the truncation in the address lookup is to have several smaller lookup tables in parallel and use the upper bits to index into the tables and the lower bits to weigh them for linear or quadratic interpolation. Ie use a 24-bit phase accumulator to look up into two 16-bit LUTS. Address into the truncated 16 MSBs, and that plus 1.