Search results
Results from the WOW.Com Content Network
In vacuum applications, a cold trap is a device that condenses all vapors except the permanent gases (hydrogen, oxygen, and nitrogen) into a liquid or solid. [ 2 ] [ needs update ] The most common objective is to prevent vapors being evacuated from an experiment from entering a vacuum pump where they would condense and contaminate it.
An oxygen concentrator takes in air and removes nitrogen from it, leaving an oxygen-enriched gas for use by people requiring medical oxygen due to low oxygen levels in their blood. [4] Oxygen concentrators provide an economical source of oxygen in industrial processes, where they are also known as oxygen gas generators or oxygen generation plants.
The conversion of the oxygen gas [15 O]O 2 to 15 O-water can happen in two ways: the in-target production and the out-of-target external conversion.The in-target production method uses a small amount of hydrogen (about 5%) that is added to the gas, whereby 15 O-water is formed and trapped in a cooled stainless steel loop.
An explosion can occur due to the common use of liquid nitrogen in the cold trap, used to protect the vacuum pump from solvents. If a reasonable amount of air is allowed to enter the Schlenk line, liquid oxygen can condense into the cold trap as a pale blue liquid.
Fountains aerate water by spraying it into the air. Water aeration is the process of increasing or maintaining the oxygen saturation of water in both natural and artificial environments. Aeration techniques are commonly used in pond, lake, and reservoir management to address low oxygen levels or algal blooms.
Since the ratio of 18 O to total water oxygen in the body is measured, we can convert 18 O loss in respiration to total oxygen lost from the body's water pool via conversion to carbon dioxide. How much oxygen left the body as CO 2 is the same as the CO 2 produced by metabolism, since the body only produces CO 2 by this route.
An azeotropic mixture of toluene and water distills out of the reaction, but only the toluene (density 0.865 g/ml) returns, since it floats on top of the water (density 0.998 g/ml), which collects in the trap. Some high-boiling liquids that have an azeotrope with water can be dried by adding toluene or another azeotrope-breaking solvent to ...
Maintaining the water seal is critical to trap operation; traps might dry out, and poor venting can suction or blow water out of the traps. This is usually avoided by venting the drain pipes downstream of the trap; by being vented to the atmosphere outside the building, the drain lines never operate at a pressure much higher or lower than ...