Search results
Results from the WOW.Com Content Network
Jumbo frames have payloads greater than 1500 bytes. In computer networking, jumbo frames are Ethernet frames with more than 1500 bytes of payload, the limit set by the IEEE 802.3 standard. [1] The payload limit for jumbo frames is variable: while 9000 bytes is the most commonly used limit, smaller and larger limits exist.
By default, it is enabled only for incoming connections that request it. It can also be enabled for all connections or disabled entirely. [13] NetBSD 4.0 implements ECN support for TCP; it can be activated through the sysctl interface by setting 1 as value for the sysctl net.inet.tcp.ecn.enable parameter. [14]
In packet-switched computer networks, a jumbogram (portmanteau of jumbo and datagram) is an internet-layer packet exceeding the standard maximum transmission unit (MTU) of the underlying network technology. In contrast, large packets for link-layer technologies are referred to as jumbo frames.
Ethernet packet. The SFD (start frame delimiter) marks the end of the packet preamble. It is immediately followed by the Ethernet frame, which starts with the destination MAC address. [1] In computer networking, an Ethernet frame is a data link layer protocol data unit and uses the underlying Ethernet physical layer transport mechanisms.
An overwhelmed network node can send a pause frame, which halts the transmission of the sender for a specified period of time. A media access control (MAC) frame (EtherType 0x8808) is used to carry the pause command, with the Control opcode set to 0x0001 (hexadecimal). [1] Only stations configured for full-duplex operation may send pause frames.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
An example of the fragmentation of a protocol data unit in a given layer into smaller fragments. IP fragmentation is an Internet Protocol (IP) process that breaks packets into smaller pieces (fragments), so that the resulting pieces can pass through a link with a smaller maximum transmission unit (MTU) than the original packet size.
In IEEE 802 networks such as Ethernet or IEEE 802.11, each frame includes a destination MAC address. In non-promiscuous mode, when a NIC receives a frame, it drops it unless the frame is addressed to that NIC's MAC address or is a broadcast or multicast addressed frame. In promiscuous mode, however, the NIC allows all frames through, thus ...