Search results
Results from the WOW.Com Content Network
A hemispherical head ("hemi-head") gives an efficient combustion chamber with minimal heat loss to the head, and allows for two large valves.However, a hemi-head usually allows no more than two valves per cylinder due to the difficulty in arranging the valve gear for four valves at diverging angles, and these large valves are necessarily heavier than those in a multi-valve engine of similar ...
Chrysler developed its first experimental hemi engine for the Republic P-47 Thunderbolt fighter aircraft. The XIV-2220 was an inverted V16 rated at 2,500 hp (1,860 kW). The P-47 was already in production with a Pratt & Whitney radial engine when the XIV-2220 flew successfully in trials in 1945 as a possible upgrade, but the war was winding down and it did not go into production.
Pent-roof combustion chamber. Cylinder head of the Nissan VQ35DE engine. In engine design, the penta engine (or penta head) is an arrangement of the upper portion of the cylinder and valves that is common in engines using four valves per cylinder. [1] Among the advantages is a faster burn time of the air-fuel mix. [2]
The Chrysler XIV-2220 (XI-2220 from 1944) was an experimental 2,500 hp, 2,220 cubic inch (36.4 liter) liquid-cooled inverted- V-16 World War II aircraft engine. Although several aircraft designs had considered using it, by the time it was ready for use in 1945 the war was already over. Only a few engines were built by Chrysler during a program ...
OHV 2 valves x cyl. The Polyspheric or Poly engines were V8 engines produced by Chrysler from 1955 to 1958 as lower-cost alternatives to the Hemi engines. [1] These engines were based on the Hemi engines, using the same blocks and crankshaft parts, but completely different cylinder heads, pushrods, exhaust manifolds and pistons.
Intended to deal with the troubles created by the low-production 426, of which only about 9,000 were built from 1966 to 1972), [4] as well as the different architectures of the higher-volume 383 cu in (6.3 L) and 400 cu in (6.6 L) B and 440 cu in (7.2 L) RB V8s, the ball-stud hemi was to be suitable for high-volume manufacture at low cost while ...
The Chrysler B and RB engines are a series of big-block V8 gasoline engines introduced in 1958 to replace the Chrysler FirePower (first generation Hemi) engines. The B and RB engines are often referred to as "wedge" engines because they use wedge-shaped combustion chambers; this differentiates them from Chrysler's 426 Hemi big block engines that are typically referred to as "Hemi" or "426 Hemi ...
Tom Hoover was the leading engineer of the Chrysler 426 Hemi engine. Tom Hoover's development of the first trademarked Hemi engine through Chrysler Corporation was a major success for the brand through the mid to late 1960s and early 1970s. The original 426 cubic inch Hemi converted to a massive 7.0 liter displacement in current terminology ...