Ad
related to: tree measurement guide
Search results
Results from the WOW.Com Content Network
Most champion tree programs focus finding and measuring the largest single-trunk example of each species. There are three basic parameters commonly measured to characterize the size of a single trunk tree: tree height measurement, tree girth measurement, and tree crown measurement. Foresters also perform tree volume measurements.
Tree girth measurement diagram. Tree girth is a measurement of the circumference of tree trunk. It is one of the most ancient, quickest, and simplest of foresters' measures of size and records of growth of living and standing trees. The methods and equipment have been standardized differently in different countries.
The first publication describing the process was in the book "Stalking the Forest Monarchs - A Guide to Measuring Champion Trees," published by Will Blozan, Jack Sobon, and Robert Leverett in early 1997 [23] [24] The technique was soon adopted by other big tree surveyors in other areas of the world. Brett Mifsud (2002) writes: "New techniques ...
When stocking, a tree's basal area is measured. The basal area is a cross-sectional area of the stump taken about 4.5 feet (1.4 m) above the ground. [7] The equation for calculating the basal area of trees in a stand is Basal Area = 0.005454 DBH 2, where DBH is the diameter of the tree at the aforementioned measuring height. [7]
Measurement of tree circumference, the tape calibrated to show diameter, at breast height, making sure that the tape is perfectly level and that the tape is not kinked, so as not to skew the reading of the diameter. Diameter at breast height, or DBH, is a standard method of expressing the diameter of the trunk or bole of a standing tree.
The left side of the stick is flush with the left side of the tree. The number where the right side of the tree lines up with the stick is the approximate DBH of the tree. To measure height, the user stands a fixed distance from the tree, usually 66 feet (20 m) in the United States.
This height is noted and the diameter of the tree is measured at that point. The climber then rappels down the tree measuring the trunk circumference by tape wrap at different heights with the height of each measurement referenced to the fixed tape running down the trunk. [citation needed] Direct trunk measurements are obtained by a tree climber.
where BA is stand basal area, n is the number of trees, and k is a constant based on measurement units - for BA in ft 2 and DBH in inches, k=0.005454; for BA in m 2 and DBH in cm, k=0.00007854. References
Ad
related to: tree measurement guide