Search results
Results from the WOW.Com Content Network
The STC provides a standardized way to compare products such as doors and windows made by competing manufacturers. A higher number indicates more effective sound insulation than a lower number. The STC is a standardized rating provided by ASTM E413 based on laboratory measurements performed in accordance with ASRM E90. ASTM E413 can also be ...
It is occasionally used to rate floor coverings. [7] NRC is intended to be a simplified acoustical rating of room construction and finish materials when the acoustical objectives of the space are less than sensitive. The NRC average is rounded to the nearest 0.05 due to a typical lab repeatability of ±0.05 for 2 standard deviations.
The Sound Reduction Index is expressed in decibels (dB). It is the weighted sound reduction index for a partition or single component only. This is a laboratory-only measurement, which uses knowledge of the relative sizes of the rooms in the test suite, and the reverberation time in the receiving room, and the known level of noise which can pass between the rooms in the suite by other routes ...
A03 Ventilation Design topic, the WELL assured building to have existing or new mechanical ventilation systems following ASHRAE 62.1-2 or EN standard 16798-1 or AS 1668.2 or CIBSE Guide A: Environmental Design. Naturally ventilation can also be used without mechanical ventilation system if the design follows Natural Ventilation Procedure in ...
Speech Transmission Index (STI) is a measure of speech transmission quality. The absolute measurement of speech intelligibility is a complex science. The STI measures some physical characteristics of a transmission channel (a room, electro-acoustic equipment, telephone line, etc.), and expresses the ability of the channel to carry across the characteristics of a speech signal.
The article states that STC ratings before 1999 would be unreliable, however the chart of values was taken from a book published in 1994. —Preceding unsigned comment added by 204.128.192.3 ( talk ) 20:58, 30 September 2009 (UTC) [ reply ]
The "ceiling effect" is one type of scale attenuation effect; [1] the other scale attenuation effect is the "floor effect".The ceiling effect is observed when an independent variable no longer has an effect on a dependent variable, or the level above which variance in an independent variable is no longer measurable. [2]
The OSNR is the ratio between the signal power and the noise power in a given bandwidth. Most commonly a reference bandwidth of 0.1 nm is used. This bandwidth is independent of the modulation format, the frequency and the receiver. For instance an OSNR of 20 dB/0.1 nm could be given, even the signal of 40 GBit DPSK would not fit in this bandwidth.