Search results
Results from the WOW.Com Content Network
Trigger guard of a SG 550 rifle. A trigger guard is a protective loop surrounding the trigger of a firearm designed to prevent unwanted contact with the trigger, which may cause an accidental discharge. [1] Other devices that use a trigger-like actuator mechanism, such as inhalers, crossbows and power tools, may also have trigger guards.
A forced reset trigger (or "hard reset" trigger) is a device that allows a person to fire a semi-automatic firearm at an increased rate. The forced reset trigger works by mechanically resetting the trigger's position after a shot is fired. This allows for an increased rate of fire.
Firearms use triggers to initiate the firing of a cartridge seated within the gun barrel chamber.This is accomplished by actuating a striking device through a combination of mainspring (which stores elastic energy), a trap mechanism that can hold the spring under tension, an intermediate mechanism to transmit the kinetic energy from the spring releasing, and a firing pin to eventually strike ...
A detent is a mechanical or magnetic means to resist or arrest the movement of a mechanical device. [1] Such a device can be anything ranging from a simple metal pin to a machine. The term is also used for the method involved. Magnetic detents are most often used to divide a shaft rotation into discrete increments.
Detent-delayed blowback uses a spring loaded detent installed inside the bolt (IE: a roll-pin) that locks itself into a notch on the end section of the guide rod closest to the barrel chamber rather than a section of the receiver/trunnion. [62] Removing the detents from the bolt would turn the operation into a simple blowback operation.
A binary trigger (or pull and release trigger) is a type of device that allows a semi-automatic firearm to fire at an increased rate. A binary trigger works by firing one shot upon pulling the trigger and then firing a subsequent shot upon release of the trigger. Binary triggers are installed through modification of the fire-control group.
Sear shown in a revolver action. In a firearm, the sear is the part of the trigger mechanism that holds the hammer, striker, or bolt back until the correct amount of pressure has been applied to the trigger, at which point the hammer, striker, or bolt is released to discharge the weapon.
A hell-fire trigger is a device that allows a semi-automatic firearm to fire at an increased rate. The hell-fire clamps to the trigger guard behind the trigger and presses a "finger" against the back of the trigger to increase the force that returns the trigger to its forward position, effectively decreasing the time required for the trigger to reset, allowing for a faster follow-up shot.