Search results
Results from the WOW.Com Content Network
The upper bucket is used to place the wet mop for storage and press handle to wring out the mop. Water trickles down to another bucket below, which collects the waste water. In some carts, there are separate lower front bucket to collect waste water. The smaller lower rear bucket is filled with a floor cleaning solution. Wheels are usually ...
T. W. Stewart wet mop from 1893. A mop (such as a floor mop) is a mass or bundle of coarse strings or yarn, etc., or a piece of cloth, sponge or other absorbent material, attached to a pole or stick. It is used to soak up liquid, for cleaning floors and other surfaces, to mop up dust, or for other cleaning purposes. [1]
A tape head cleaner is a substance or device used for cleaning the record and playback heads of a magnetic tape drive found in video or audio tape machines such as cassette players and VCRs. [1] These machines require regular maintenance to perform properly.
Swinging head (or swinging bucket) centrifuges, in contrast to fixed-angle centrifuges, have a hinge where the sample containers are attached to the central rotor. This allows all of the samples to swing outwards as the centrifuge is spun. Continuous tubular centrifuges do not have individual sample vessels and are used for high volume ...
A bucket wheel excavator (BWE) consists of a superstructure to which several more components are fixed. The bucket wheel from which the machines get their name is a large, round wheel with a configuration of scoops which is fixed to a boom and is capable of rotating. Material picked up by the cutting wheel is transferred back along the boom.
This style elevator bucket operates off a double strand chain; the buckets are held in place by two pins so that they can swivel freely. To discharge the bucket, it is mechanically flipped, but until then the bucket is held parallel to the floor and upright. These elevators typically form an "S" or "L" in design and run throughout a plant.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
The cleaning process is typically done through either a pressurized device (e.g., a bidet or a bidet shower) or a non-pressurized vessel (e.g., a lota or an aftabeh) alongside a person's hand; many cultures assert that only the left hand is to be used for this task. Washing is sometimes followed by drying the cleaned areas with a cloth towel.