Search results
Results from the WOW.Com Content Network
Float shifting can reduce clutch wear because it is used so much less (only for starting from a standstill). Conversely, improper engagement of a gear (when the engine and transmission speeds aren't matched) can cause wear on the synchros and lockouts, and damage the gears by physically grinding them together due to a difference in speed.
General Motors provided a fix for "Noise #1" but stated that "Noise #2" was a characteristic of any car equipped with a manual transmission and that a similar noise could be repeated by lugging the engine. The remedy for "Noise #1" was to overfill the transmission with Saturn Manual Transmission Lubricant from the stock 1.8 quarts to 2.6 quarts.
In 1993, the RZ362A, the first high-performance gear grinding machine, made its entry into the automotive industry. With this machine, Reishauer introduces the Low Noise Shifting (LNS) process, which reduced unwanted gear noise.
Floor-mounted gear stick in a Mazda Protege passenger car Common shift pattern for a 5-speed transmission. In most vehicles with a manual transmission, the driver selects gears by manipulating a lever called a gear stick (also called a gearshift, gear lever or shifter). In most automobiles, the gear stick is located on the floor between the ...
The clutch brake not only slows or stops the idle gear axis but can also prevent shifting into gear until the clutch pedal is released a few centimetres (or inches) off the floor. In order to shift into gear, the clutch must be halfway off the floor, otherwise, the clutch brake will prevent the transmission from being shifted into or out of gear.
Before the introduction of transmission synchronizers in 1927, [2] double clutching was a technique required to prevent damage to an automobile's gearing during shifts. Due to the difficulty and most often unnecessary redundancy involved in the technique, coupled with the advent of synchronized gearing systems, it has largely fallen into disuse in light vehicles.
The original buses had a four-speed non-synchronized Spicer manual transmission with a solenoid reverse. [1]: 317 The 4107 and 4903 models were notorious for being difficult to shift through the gears, often making loud, grinding noises that tended to upset the passengers. The technique known as "double-clutching" reduced these noises, but even ...
In 1923, a patent was approved in the United States describing the operation of a transmission where the manual shifting of gears and manual operation of a clutch was eliminated. This patent was submitted by Henry R. Hoffman from Chicago and was titled: Automatic Gear Shift and Speed Control. The patent described the workings of such a ...