enow.com Web Search

  1. Ad

    related to: rear tire making thumping noise when coasting turn wheel stop

Search results

  1. Results from the WOW.Com Content Network
  2. Fishtailing - Wikipedia

    en.wikipedia.org/wiki/Fishtailing

    The rear tires will still be sliding sideways, and the greater friction that exists will cause the back end to trail directly behind the front end, similar to a shuttlecock in flight; thus the car straightens out. As the car straightens, the front wheels must be kept aligned with the direction the vehicle is moving, not the direction it is ...

  3. Lift-off oversteer - Wikipedia

    en.wikipedia.org/wiki/Lift-off_oversteer

    Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...

  4. Skid mark - Wikipedia

    en.wikipedia.org/wiki/Skid_mark

    Skid marks from aircraft tires on a runway. A skid mark is the visible mark left by any solid which moves against another, and is an important aspect of trace evidence analysis in forensic science and forensic engineering. Skid marks caused by tires on roads occur when a vehicle wheel stops rolling and slides or spins on the surface of the road.

  5. Rumble strip - Wikipedia

    en.wikipedia.org/wiki/Rumble_strip

    Motor vehicle tires can become permanently damaged if a flat occurs in the traffic lane and the driver pulls over onto the shoulder with the flat tire passing over the rumble strip. This may cause the flat tire's sidewalls to be crushed or abraded between the metal wheel rim and rumble strip high-points. [citation needed]

  6. Roadway noise - Wikipedia

    en.wikipedia.org/wiki/Roadway_noise

    Roadway noise is the collective sound energy emanating from motor vehicles. It consists chiefly of road surface, tire, engine/transmission, aerodynamic, and braking elements. Noise of rolling tires driving on pavement is found to be the biggest contributor of highway noise and increases with higher vehicle speeds. [1] [2] [3]

  7. Camber angle - Wikipedia

    en.wikipedia.org/wiki/Camber_angle

    The 1960 Milliken MX1 Camber Car has a large negative camber. Camber angle is one of the angles made by the wheels of a vehicle; specifically, it is the angle between the vertical axis of a wheel and the vertical axis of the vehicle when viewed from the front or rear.

  8. Wheelspin - Wikipedia

    en.wikipedia.org/wiki/Wheelspin

    In low traction situations, the total torque delivered to each wheel is limited to the torque that is required to make the wheel with the least traction slip. During a turn, the weight of the vehicle shifts away from the inner radius and to the outer radius, therefore the inner drive-wheel will often lose traction on hard cornering, and ...

  9. Spare tire - Wikipedia

    en.wikipedia.org/wiki/Spare_tire

    A spare tire allows a driver to replace a flat tire and drive on A Stepney rim. An early approach to providing a car with a spare tire Dual sidemounted spare tires behind the front fenders on a 1931 Nash Ambassador Temporary use "space-saver" spare tire mounted in the trunk of a 1970 AMC AMX with a single use air canister Full size spare tire mounted in cargo space area of a 1993 Jeep Grand ...

  1. Ad

    related to: rear tire making thumping noise when coasting turn wheel stop