Search results
Results from the WOW.Com Content Network
The term furlong, or shot, was also used to describe a grouping of adjacent strips within an open field. [3] Among the early Anglo-Saxons, the rod was the fundamental unit of land measurement. A furlong was 40 rods; an acre 4 by 40 rods, or 4 rods by 1 furlong, and thus 160 square rods; there are 10 acres in a square furlong.
A fathom is a unit of length in the imperial and the U.S. customary systems equal to 6 feet (1.8288 m), used especially for measuring the depth of water. [1] The fathom is neither an international standard (SI) unit, nor an internationally accepted non-SI unit. Historically it was the maritime measure of depth in the English-speaking world but ...
The furlong–firkin–fortnight (FFF) system is a humorous system of units based on unusual or impractical measurements. The length unit of the system is the furlong , the mass unit is the mass of a firkin of water, and the time unit is the fortnight .
fathom (for depth; only in non-metric countries) (2 yards = 1.8288 m) nautical mile (one minute of arc of latitude = 1852 m) Aviation. ... furlong = 1 ⁄ 8 mile (201 ...
An area of land one chain (four rods) wide by one furlong in length. As the traditional furlong could vary in length from country to country, so did the acre. In England an acre was 4,840 square yards (4,050 m 2 ), in Scotland 6,150 square yards (5,140 m 2 ) and in Ireland 7,840 square yards (6,560 m 2 ).
Fathom: Length: Knot: Speed: League: Length: Nautical mile: Length: Rhumb: Angle: The angle between two successive points of the thirty-two point compass (11 degrees 15 minutes) (rare) [1] Shackle: Length: Before 1949, 12.5 fathoms; later 15 fathoms. [2] Toise: Length: Toise was also used for measures of area and volume Twenty-foot equivalent ...
furlong; mile; The best-attested of these is the perch, which varied in length from 10 to 25 feet, with the most common value (16 1 ⁄ 2 feet or 5.03 m) remaining in use until the twentieth century. [1] Later development of the English system continued in 1215 in the Magna Carta. [2] Standards were renewed in 1496, 1588 and 1758. [3]
The former Weights and Measures office in Seven Sisters, London (590 Seven Sisters Road). The imperial system of units, imperial system or imperial units (also known as British Imperial [1] or Exchequer Standards of 1826) is the system of units first defined in the British Weights and Measures Act 1824 and continued to be developed through a series of Weights and Measures Acts and amendments.