Search results
Results from the WOW.Com Content Network
The actual voltage, matching the car battery's voltage, will be approximately 12.5 volts when dormant (less in cold conditions), approximately 14.5 volts when the engine and the alternator/generator are operating (more when cold), and may briefly drop as low as 5–6 volts during engine start due to the high temporary battery current usage. [12]
The switch will operate in a make-before-break mode provided both sources are acceptable and synchronized. Typical parameters determining synchronization are: voltage difference less than 5%, frequency difference less than 0.2 Hz, and maximum phase angle between the sources of 5 degrees.
A typical 12 V, 40 Ah lead-acid car battery. An automotive battery, or car battery, is a rechargeable battery that is used to start a motor vehicle.. Its main purpose is to provide an electric current to the electric-powered starting motor, which in turn starts the chemically-powered internal combustion engine that actually propels the vehicle.
There is essentially no difference in efficiency between the technique of bypassing the throttle butterfly and operating the butterfly itself. The IAC allows the ECU to maintain minimum RPM irrespective of changes in engine load, sometimes referred to as anti-stall feature. Thus the driver can more easily move the car from stand-still by merely ...
Ordinary valves can have many ports and fluid paths. A 2-way valve, for example, has 2 ports; if the valve is open, then the two ports are connected and fluid may flow between the ports; if the valve is closed, then ports are isolated. If the valve is open when the solenoid is not energized, then the valve is termed normally open (N.O.).
General Motors, and other automobile manufacturers, have also begun using side-post battery terminals, which consist of two recessed female 3/8" threads (SAE 3/8-16) into which bolts or various battery terminal adapters are to be attached. These side posts are of the same size and do not prevent incorrect polarity connections.
A crossflow head gives better performance than a Reverse-flow cylinder head (though not as good as a uniflow), but the popular explanation put forward for this — that the gases do not have to change direction and hence are moved into and out of the cylinder more efficiently — is a simplification since there is no continuous flow because of valve opening and closing.
In an alternating current (AC) electric power system, synchronization is the process of matching the frequency, phase and voltage of a generator or other source to an electrical grid in order to transfer power. If two unconnected segments of a grid are to be connected to each other, they cannot safely exchange AC power until they are synchronized.