Search results
Results from the WOW.Com Content Network
Other units of pressure, such as pounds per square inch (lbf/in 2) and bar, are also in common use. The CGS unit of pressure is the barye (Ba), equal to 1 dyn·cm −2, or 0.1 Pa. Pressure is sometimes expressed in grams-force or kilograms-force per square centimetre ("g/cm 2" or "kg/cm 2") and the like without properly identifying the force ...
The pound per square inch (abbreviation: psi) or, more accurately, pound-force per square inch (symbol: lbf/in 2), [1] is a unit of measurement of pressure or of stress based on avoirdupois units and used primarily in the United States. It is the pressure resulting from a force with magnitude of one pound-force applied to an area of one square ...
The units of atmospheric pressure commonly used in meteorology were formerly the bar (100,000 Pa), which is close to the average air pressure on Earth, and the millibar. Since the introduction of SI units , meteorologists generally measure atmospheric pressure in hectopascals (hPa), equal to 100 pascals or 1 millibar.
Force per unit oriented surface area Pa L −1 M T −2: order 2 tensor Surface tension: γ: Energy change per unit change in surface area N/m or J/m 2: M T −2: Thermal conductance κ (or) λ: Measure for the ease with which an object conducts heat W/K L 2 M T −3 Θ −1: extensive Thermal conductivity: λ: Measure for the ease with which a ...
In the cgs system the unit of pressure was the barye (ba), equal to 1 dyn·cm −2. In the mts system, the unit of pressure was the pieze, equal to 1 sthene per square metre. Many other hybrid units are used such as mmHg/cm 2 or grams-force/cm 2 (sometimes as kg/cm 2 without properly identifying the force units). Using the names kilogram, gram ...
Units for other physical quantities are derived from this set as needed. In English Engineering Units, the pound-mass and the pound-force are distinct base units, and Newton's Second Law of Motion takes the form = where is the acceleration in ft/s 2 and g c = 32.174 lb·ft/(lbf·s 2).
The coefficient of lift for a two-dimensional airfoil section with strictly horizontal surfaces can be calculated from the coefficient of pressure distribution by integration, or calculating the area between the lines on the distribution. This expression is not suitable for direct numeric integration using the panel method of lift approximation ...
is pressure head (which is actually a length, typically in units of meters or centimetres of water) is fluid pressure (i.e. force per unit area, typically expressed in pascals) is the specific weight (i.e. force per unit volume, typically expressed in N/m 3 units)