Search results
Results from the WOW.Com Content Network
A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]
Cable entry systems are used for routing electrical cables, corrugated conduits or pneumatic and hydraulic hoses into switch cabinets, electrical enclosures, control panels and machines or in large heavy-duty vehicles, rolling stock and ships. Possible requirements can be high ingress protection rates or integrated strain relief. [1]
Cable grommets. A cable grommet is a tube or ring through which an electrical cable passes. They are usually made of rubber or metal. [1]The grommet is usually inserted in holes in certain materials in order to protect, improve friction or seal cables passing through it, from a possible mechanical or chemical attack.
Strain insulators on high-voltage power lines. A strain insulator is an electrical insulator that is designed to work in mechanical tension (strain), to withstand the pull of a suspended electrical wire or cable. They are used in overhead electrical wiring, to support radio antennas and overhead power lines. A strain insulator may be inserted ...
The telephone jack of manual telephone switchboards, which is the socket fitting the original 1 ⁄ 4 inch (6.35 mm) telephone plug; The 1 ⁄ 4 inch (6.35 mm) phone jack common to many electronic applications in various configurations, sometimes referred to as a headphone jack
6 inch (15 cm) outside diameter, oil-cooled cables, traversing the Grand Coulee Dam throughout. An example of a heavy cable for power transmission. Fire test in Sweden, showing fire rapidly spreading through the burning of cable insulation, a phenomenon of great importance for cables used in some installations. 500,000 circular mil (254 mm 2) single conductor power cable
Cable grommets. Holes in metal or another hard material will often have sharp edges. [6] Electrical wires, cord, rope, lacings, or other soft vulnerable material passing through the hole can become abraded or cut, or electrical insulation may break due to repeated flexing at the exit point of the casing of a junction box for example. [6]
The addition is a 3 ⁄ 16-inch (4.8 mm) diameter round or U-shaped ground pin, 1 ⁄ 8 in (3.2 mm) longer than the power blades (so the device is grounded before the power is connected) and located from them by 1 ⁄ 4 in (6.4 mm) edge-to-edge or 15 ⁄ 32 in (11.9 mm) center-to-center.