enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   Tapcon screws are a popular anchor that stands for self tapping (self threading) concrete screw. Larger diameter screws are referred to as LDT's. This type of fastener requires a pre-drilled hole—using a Tapcon drillbit—and are then screwed into the hole using a standard hex or phillips bit.

3. Offshore embedded anchors - Wikipedia

   en.wikipedia.org/wiki/Offshore_embedded_anchors

   A deep-penetrating anchor (DPA) is conceptually similar to a torpedo anchor: it features a dart-shaped, thick-walled, steel cylinder with flukes attached to the upper section of the anchor. A full-scale DPA is approximately 15 metres (49 ft) in length, 1.2 metres (4 ft) in diameter, and weighs on the order of 50–100 tonnes (49–98 long tons ...

4. Precast concrete lifting anchor system - Wikipedia

   en.wikipedia.org/wiki/Precast_concrete_lifting...

   The anchor selection, together with additional reinforcement, and rigging arrangements is influenced by: - The dead weight of the element - The number of anchors in the element and the configuration of the anchor - Capacity of the anchor at the specific concrete compressive strengths at time of lift - The dynamic loads applied during lifting ...

5. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   Self-tapping screws can be divided into two classes: [3] those that displace material (especially plastic and thin metal sheets) without removing it, known as "thread-forming" self-tapping screws, and self-tappers with sharp cutting surfaces that remove the material as they are inserted, termed "thread-cutting" self-tapping screws.

6. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...

7. Anchor - Wikipedia

   en.wikipedia.org/wiki/Anchor

   Auger anchors can be used to anchor permanent moorings, floating docks, fish farms, etc. These anchors, which have one or more slightly pitched self-drilling threads, must be screwed into the seabed with the use of a tool, so require access to the bottom, either at low tide or by use of a diver.

8. Amazon's Presidents' Day sale just kicked off — save ... - AOL

   www.aol.com/lifestyle/amazon-presidents-day-2025...

   DEWALT 20V MAX Cordless Drill and Impact Driver. $139 $239 Save $100 with Prime. See at Amazon. ... The iRobot j9+ self-emptying robot vacuum is down to the year's lowest price at just $499.

9. Anchor channel - Wikipedia

   en.wikipedia.org/wiki/Anchor_channel

   Anchor channels, invented by Anders Jordahl in 1913, are steel channels cast flush in reinforced concrete elements to allow the installation of channel bolts for the fastening of components. Anchor channels consist of steel C-shaped channels and anchors (mostly headed studs ) which are connected to the channel by welding or riveting/forging.