Search results
Results from the WOW.Com Content Network
Head restraint in a Lincoln Town Car. Head restraints (also called headrests) are an automotive safety feature, attached or integrated into the top of each seat to limit the rearward movement of the adult occupant's head, relative to the torso, in a collision — to prevent or mitigate whiplash or injury to the cervical vertebrae.
The final model C3 Corvette's published performance numbers were 0-60 mph in 7.9 seconds-the quarter-mile in 16.1 at 85 mph (137 km/h). This was the last year for 8-track tape availability and new "cross-fire injection" emblems appeared on front fenders.
1969 Corvette Stingray coupe with T-top panels removed. The third-generation Corvette, patterned after the Mako Shark II concept car, was introduced for the 1968 model year and was in production until 1982. C3 coupes featured the first use of T-top removable roof panels. It introduced monikers that were later revived, such as LT-1, ZR-1, Z07 ...
The third factor in the Corvette's survival was Ford's introduction of the 1955 two-seat Thunderbird. [24] The Ford model featured a V8 engine, was better equipped, and positioned more as a "personal car" rather than a pure sports car. [25] Even so, the Ford-Chevrolet rivalry in those days demanded GM not appear to back down from the challenge.
A rear-engined Corvette was briefly considered during 1958–60, progressing as far as a full-scale mock-up designed around the Corvair's entire rear-mounted power package, including its air-cooled flat-six, as an alternative to the Corvette's usual water-cooled V8. By the fall of 1959, elements of the Q-Corvette and the Sting Ray Special racer ...
The Pontiac GTO is a front-engine, rear-drive, two-door and four-passenger automobile manufactured and marketed by the Pontiac division of General Motors over four generations from 1963 until 1974 in the United States — with a fifth generation made by GM's Australian subsidiary, Holden, for the 2004 through 2006 model years.
1969 Corvette Stingray — After dropping the "Sting Ray" name from the Corvette in 1968, it returned as a single word in 1969 and would continue until 1976. [ 34 ] 1992 Stingray III — This product of the Advanced Concept Center in California featured fixed seats with adjustable steering wheel and pedals, a pop-up rollbar, all-wheel steering ...
The bucket seats were of a one-piece high-back design with built-in headrests and could swivel almost 90 degrees to permit the driver and front passenger easier entry and exit, a feature previously offered on the 1962 Chrysler 300H. Cloth and vinyl trims were offered for bench and bucket seats.