Search results
Results from the WOW.Com Content Network
In construction, asbestos abatement is a set of procedures designed to control the release of asbestos fibers from asbestos-containing materials. [1] Asbestos abatement is utilized during general construction in areas containing asbestos materials, particularly when those materials are being removed, encapsulated, or repaired.
Asbestos (/ æ s ˈ b ɛ s t ə s, æ z-,-t ɒ s / ass-BES-təs, az-, -toss) [1] is a group of naturally occurring, toxic, carcinogenic and fibrous silicate minerals.There are six types, all of which are composed of long and thin fibrous crystals, each fibre (particulate with length substantially greater than width) [2] being composed of many microscopic "fibrils" that can be released into ...
Asbestos cement, genericized as fibro, fibrolite (short for "fibrous (or fibre) cement sheet"; but different from the natural mineral fibrolite), or AC sheet, is a composite building material consisting of cement and asbestos fibres pressed into thin rigid sheets and other shapes.
It can also be found in insulation, siding, roof gutters, and cement wallboard. The more prevalent transite found in wall construction and roofing tiles for example, will last anywhere from 50 years to over 100 years. [citation needed] The use of asbestos, a proven carcinogen, to manufacture transite was phased out in the 1980s.
Asbestos shingles are roof or wall shingles made with asbestos cement board. They often resemble slate shingles and were mass-produced during the 20th century as these were more resilient to weathering than traditional slate shingles for the reason that slate is very soft and prone to weathering.
Three polytypes of chrysotile are known. [8] These are very difficult to distinguish in hand specimens, and polarized light microscopy [6] must normally be used. Some older publications refer to chrysotile as a group of minerals—the three polytypes listed below, and sometimes pecoraite as well—but the 2006 recommendations of the International Mineralogical Association prefer to treat it as ...
Construction workers who inhale asbestos from contaminated building materials such as paint, spackling, roof shingles, masonry compounds, and drywall may get asbestosis. The amount and length of an individual's exposure to asbestos are the primary factors that determine the level of risk.
Asbestos warts: caused when the sharp fibers lodge in the skin and are overgrown causing benign callus-like growths. Pleural plaques: discrete fibrous or partially calcified thickened area which can be seen on X-rays of individuals exposed to asbestos. Although pleural plaques are themselves asymptomatic, in some patients this develops into ...