enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wiring diagram - Wikipedia

   en.wikipedia.org/wiki/Wiring_diagram

   A set of wiring diagrams may be required by the electrical inspection authority to approve connection of the residence to the public electrical supply system. Wiring diagrams will also include panel schedules for circuit breaker panelboards, and riser diagrams for special services such as fire alarm or closed-circuit television or other special ...

3. Electronic symbol - Wikipedia

   en.wikipedia.org/wiki/Electronic_symbol

   An electronic symbol is a pictogram used to represent various electrical and electronic devices or functions, such as wires, batteries, resistors, and transistors, in a schematic diagram of an electrical or electronic circuit. These symbols are largely standardized internationally today, but may vary from country to country, or engineering ...

4. Circuit diagram - Wikipedia

   en.wikipedia.org/wiki/Circuit_diagram

   A less common symbol is simply a series of peaks on one side of the line representing the conductor, rather than back-and-forth. Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle ...

5. Electrical wiring in North America - Wikipedia

   en.wikipedia.org/wiki/Electrical_wiring_in_North...

   Black, Red and Blue are used for hot wires and White is used as the neutral wire in a 120/208 V circuit. Brown, Orange and Yellow are used as hot wires and gray is used as the neutral wire in a 277/480 V. For grounding, regardless of the voltage, Green (or a bare wire) is used.

6. Reference designator - Wikipedia

   en.wikipedia.org/wiki/Reference_designator

   Connectors on this cable would be designated: 1A1W35P1; 1A1W35P2; ASME Y14.44-2008 continues the convention of Plug P and Jack J when assigning references for electrical connectors in assemblies where a J (or jack) is the more fixed and P (or plug) is the less fixed of a connector pair, without regard to the gender of the connector contacts.

7. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   This allows one to choose single-phase AC power at either 110–120 volts between phase and neutral or 220–240 volts between phase and phase. Since these two modes do not need three phases there is also a dark yellow-orange four-pin connector available designed for a single-phase 110–120 or 220–240 volt load.