Search results
Results from the WOW.Com Content Network
The Ford–GM 10-speed automatic transmission is part of a joint venture between Ford Motor Company and General Motors to design and engineer two transmissions: a longitudinal 10-speed transmission and a transverse 9-speed trans-axle. Each company manufactures its own unique version of the transmissions in its own factories.
TK 4 4 speed manual (No Overdrive) (Ranger, Bronco II 83-85, Aerostar 85) TK 5 5 speed manual (With overdrive) (Ranger, Bronco II 85-87, Aerostar 85-87) Mitsubishi FM145/FM146 5 speed (overdrive) (Ranger/Bronco II 86-92 with 2.0L, 2.3L, and 2.9L engines only) ZF Transmissions S5-42- Late 80’s and early 90’s F-250+ S5-47- Mid 90’s to 2000 ...
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
Ford's 10-speed 10R140 TorqShift automatic transmission was now standard with the diesel and 7.3-liter gasoline engines on the F-250 and all engines on the F-350; the 6-speed was still available, but only in the F-250 with the 6.2-liter engine and even the F-350 XL DRW with the Payload Package of the same engine (though this is a rare option).
Changing the engine to a V6 often requires changing the bellhousing (Mitsubishi) but the Mazda trans had an integral bell. 2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines. Some had the same Mitsubishi manual transmission as the 2.0/2.3 but had different bellhousings. The 2.3, 2.8, and 2.9 also made it into the Ranger, and ...
Honda's older transmissions such as the Hondamatic semi-automatic transmission and its successors use traditional, individual gears on parallel axes like a manual transmission, with each gear ratio engaged by a separate hydraulic clutch pack. This design is also noteworthy because it preserves engine braking by eliminating a sprag between first ...
The 1941 Chrysler M4 Vacamatic transmission was a two-speed manual transmission with an integral underdrive unit, a traditional manual clutch, and a fluid coupling between the engine and the clutch. [ 51 ] [ 52 ] [ 53 ] The two-speed transmission had "high" and "low" ranges, and the clutch was used when the driver wanted to switch between ranges.
The police package (9C1) B-body cars featured a First Gear Block Out (FGBO) Plate on the transmission housing to prevent drivetrain damage. The shift point for first to second gear is about 43 MPH (69 km/h) while second to third gear shift point is about 83 MPH (134 km/h) assuming a 3.08:1 differential and a 5,500 RPM engine speed limit.