Search results
Results from the WOW.Com Content Network
Induction heating is a non contact heating process which uses the principle of electromagnetism induction to produce heat in a work-piece. In this case thermal expansion is used in a mechanical application to fit parts over one another, e.g. a bushing can be fitted over a shaft by making its inner diameter slightly smaller than the diameter of the shaft, then heating it until it fits over the ...
Induction heating is a non contact method of heating a conductive body by utilising a strong magnetic field.Supply (mains) frequency 50 Hz or 60 Hz induction heaters incorporate a coil directly fed from the electricity supply, typically for lower power industrial applications where lower surface temperatures are required.
The crankcase heater keeps refrigerant at a temperature higher than the coldest part of the system. A crankcase heater generally has the same electrical symbol as a resistor because it converts electricity directly into heat via electrical resistance. The resistance in the heater coil determines the heat it produces when voltage is applied. [1]
Roller bearings are the earliest known type of rolling-element-bearing, dating back to at least 40 BC. Common roller bearings use cylinders of slightly greater length than diameter. Roller bearings typically have a higher radial load capacity than ball bearings, but a lower capacity and higher friction under axial loads.
These included fingerless crankshaft bearing caps, new cast-iron camshaft supports with no bushings, inlet and outlet valves of increased diameter with double-wound-springs, a new water pump, a vibration damper on the crankshaft pulley, contactless ignition system with a new alternator, new spark plugs, and an upgraded K-126GM carburettor.
A crosshead as part of a reciprocating piston and slider-crank linkage mechanism. Cylindrical trunk guide Hudswell Clarke Nunlow; crosshead and two slide bars. In mechanical engineering, a crosshead [1] is a mechanical joint used as part of the slider-crank linkages of long stroke reciprocating engines (either internal combustion or steam) and reciprocating compressors [2] to eliminate ...
Stainless steel, also known as inox, corrosion-resistant steel (CRES), and rustless steel, is an iron-based alloy containing a minimum level of chromium that is resistant to rusting and corrosion.
The Gremlin debuted in April 1970 with AMC's 199 cu in (3.3 L) I6, a seven main bearing design which produced 128 hp (95 kW; 130 PS) as standard equipment, with AMC's 232 cu in (3.8 L) I6 - producing 145 hp (108 kW; 147 PS) - as an option. AMC said the Gremlin offered "the best gas mileage of any production car made in America".