enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Load dump - Wikipedia

   en.wikipedia.org/wiki/Load_dump

   If the battery becomes disconnected while it is being charged the load on the alternator suddenly decreases. However, the vehicle's voltage regulator cannot quickly cause the field current to decrease sufficiently, so the alternator continues to generate a large current. This large current causes the voltage on the vehicle bus to increase ...

3. Power system protection - Wikipedia

   en.wikipedia.org/wiki/Power_system_protection

   Power system protection is a branch of electrical power engineering that deals with the protection of electrical power systems from faults [citation needed] through the disconnection of faulted parts from the rest of the electrical network.

4. Blocked rotor test - Wikipedia

   en.wikipedia.org/wiki/Blocked_rotor_test

   The test is conducted at / the rated frequency as recommended by IEEE, because the rotor's effective resistance at low frequency may differ at high frequency. [7] [8] The test can be repeated for different values of voltage to ensure the values obtained are consistent. As the current through the stator may exceed the rated current, the test ...

5. Load bank - Wikipedia

   en.wikipedia.org/wiki/Load_bank

   A load bank is a piece of electrical test equipment used to simulate an electrical load, to test an electric power source without connecting it to its normal operating load. [ 1 ] [ 2 ] During testing, adjustment, calibration, or verification procedures, a load bank is connected to the output of a power source, such as an electric generator ...

6. Alternator (automotive) - Wikipedia

   en.wikipedia.org/wiki/Alternator_(automotive)

   Alternator (silver) mounted on a V8 engine Alternator voltage regulator (brushes are worn out) An alternator is a type of electric generator used in modern automobiles to charge the battery and to power the electrical system when its engine is running. Until the 1960s, automobiles used DC dynamo generators with commutators.

7. Dielectric withstand test - Wikipedia

   en.wikipedia.org/wiki/Dielectric_withstand_test

   In electrical engineering, a dielectric withstand test (also pressure test, high potential test, hipot test, or insulation test) is an electrical safety test performed on a component or product to determine the effectiveness of its insulation. The test may be between mutually insulated sections of a part, or energized parts and ground.