Search results
Results from the WOW.Com Content Network
A stuck-at fault is a particular fault model used by fault simulators and automatic test pattern generation (ATPG) tools to mimic a manufacturing defect within an integrated circuit. Individual signals and pins are assumed to be stuck at Logical '1', '0' and 'X'. For example, an input is tied to a logical 1 state during test generation to ...
In aircraft, a centrifugal switch is used to control the starting and ignition circuits, the governed speed indication circuit and the overspeed protection circuit of the auxiliary power unit. This switch is mounted inside a rotating body. This can be set to activate or deactivate a circuit as the rpm of device increases or decreases ...
The company began as a division of the Coleman Company in 1958 and was acquired by Evcon in 1990, which in turn was acquired by Johnson Controls in 1996. [70] [71] [72] Of the twelve largest American furnace brand names represented at Gas Furnace Guide, the Coleman brand received an average ranking of 3.7 out of 5 stars. [73]
If the switch is always open, the start capacitor is not part of the circuit, so the motor does not start. If the switch is always closed, the start capacitor is always in the circuit, so the motor windings will likely burn out. If a motor does not start, the capacitor is far more likely the problem than the switch. [citation needed]
A thermal expansion valve is a key element to a heat pump; this is the cycle that makes air conditioning, or air cooling, possible.A basic refrigeration cycle consists of four major elements: a compressor, a condenser, a metering device and an evaporator.
A sail switch, vane switch or flow switch is a mechanical switch that is actuated on or off in response to the flow or non-flow of a fluid such as air or water. [1] A sail switch typically operates through the use of a paddle or a diaphragm which gets displaced due to the force of fluid or air moving past it.
The G.I. pocket stove is 8 + 1 ⁄ 2 inches (220 mm) high and 4 + 1 ⁄ 2 inches (110 mm) in diameter, and weighs about 3 pounds (1.4 kg). It was designed to burn either leaded or unleaded automobile gasoline (sometimes referred to as "white gasoline" or pure gasoline, without lead or additives).
A thermal switch (sometimes thermal reset or thermal cutout (TCO)) is a device which normally opens at a high temperature (often with a faint "plink" sound) and re-closes when the temperature drops. The thermal switch may be a bimetallic strip , often encased in a tubular glass bulb to protect it from dust or short circuit .