Search results
Results from the WOW.Com Content Network
In aircraft, a centrifugal switch is used to control the starting and ignition circuits, the governed speed indication circuit and the overspeed protection circuit of the auxiliary power unit. This switch is mounted inside a rotating body. This can be set to activate or deactivate a circuit as the rpm of device increases or decreases ...
The company began as a division of the Coleman Company in 1958 and was acquired by Evcon in 1990, which in turn was acquired by Johnson Controls in 1996. [70] [71] [72] Of the twelve largest American furnace brand names represented at Gas Furnace Guide, the Coleman brand received an average ranking of 3.7 out of 5 stars. [73]
A thermal switch (sometimes thermal reset or thermal cutout (TCO)) is a device which normally opens at a high temperature (often with a faint "plink" sound) and re-closes when the temperature drops. The thermal switch may be a bimetallic strip , often encased in a tubular glass bulb to protect it from dust or short circuit .
The G.I. pocket stove is 8 + 1 ⁄ 2 inches (220 mm) high and 4 + 1 ⁄ 2 inches (110 mm) in diameter, and weighs about 3 pounds (1.4 kg). It was designed to burn either leaded or unleaded automobile gasoline (sometimes referred to as "white gasoline" or pure gasoline, without lead or additives).
A thermal expansion valve is a key element to a heat pump; this is the cycle that makes air conditioning, or air cooling, possible.A basic refrigeration cycle consists of four major elements: a compressor, a condenser, a metering device and an evaporator.
OpenTherm (OT) is a standard communications protocol used in central heating systems for the communication between central heating appliances and a thermostatic controllers. [1] As a standard, OpenTherm is independent of any single manufacturer. A controller from one manufacturer can in principle be used to control a boiler from another ...
Dry running protection, also known as dry-run protection or dry-running protection, is a type of protection mechanism to prevent a rotor, pump or stirrer shaft from operating without any medium added, as the bearing and shaft seal might be damaged if the motor is run while dry. [1]
Heat pumps therefore have a provision for occasional defrost of the outdoor coil. This is done by reversing the cycle to the cooling mode, shutting off the outdoor fan, and energizing the electric heating elements. The electric heat in defrost mode is needed to keep the system from blowing cold air inside the building.