Search results
Results from the WOW.Com Content Network
Faucet is the most common term in the US, similar in use to "tap" in British English, e.g. "water faucet" (although the term "tap" is also used in the US). Spigot is used by professionals in the trade (such as plumbers), and typically refers to an outdoor fixture.
English: In a typical leaded bell-and-spigot joint, the spigot is inserted into the bell of another pipe, yarn or oakum is compressed into the space, then hot lead was poured and also worked into the joint. Installers would typically use a set of tools, with different sized heads, to make sure both the yarn and lead were properly worked into ...
Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.
Valves stop (or regulate) the flow of liquids or gases. They are categorized by application, such as isolation, throttling, and non-return. Isolation valves temporarily disconnect part of a piping system to allow maintenance or repair, for example. Isolation valves are typically left in either a fully open or closed position.
English: Diagram of a water distribution system. Inlet water goes through a pumping station. The water is delivered to the top of a water tank. Water pressure created by gravity and delivered to water mains. Water mains are connected to fire hydrants and service lines which are pipes that connect a water main to a building.
A valve stem is a self-contained valve that opens to admit gas to a chamber (such as air to inflate a tire), [1] and is then automatically closed and kept sealed by the pressure in the chamber, or a spring, [2] [3] or both, to prevent the gas from escaping.
In a bell and spigot joint [2] one end of the pipe stick is flared, termed the bell or socket, to enable the opposite end of the next stick, the spigot end, to be inserted to create a joint. The gaps in these joints were stuffed with oakum or yarn to retain molten-lead, which solidified into a waterproof joint.
An electric multi-turn actuator on a gate valve. A gate valve, also known as a sluice valve, is a valve that opens by lifting a barrier (gate) out of the path of the fluid. Gate valves require very little space along the pipe axis and hardly restrict the flow of fluid when the gate is fully opened.