enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. USB - Wikipedia

   en.wikipedia.org/wiki/USB

   USB 3.2, released in September 2017, [39] preserves existing USB 3.1 SuperSpeed and SuperSpeedPlus architectures and protocols and their respective operation modes, but introduces two additional SuperSpeedPlus operation modes (USB 3.2 Gen 1×2 and USB 3.2 Gen 2×2) with the new USB-C Fabric with signaling rates of 10 and 20 Gbit/s (raw data ...

3. USB hardware - Wikipedia

   en.wikipedia.org/wiki/USB_hardware

   The USB Power Delivery specification revision 2.0 (USB PD Rev. 2.0) has been released as part of the USB 3.1 suite. [ 58 ] [ 65 ] [ 66 ] It covers the USB-C cable and connector with a separate configuration channel, which now hosts a DC coupled low-frequency BMC -coded data channel that reduces the possibilities for RF interference . [ 67 ]

4. PoweredUSB - Wikipedia

   en.wikipedia.org/wiki/PoweredUSB

   For comparison, a standard USB 1.x and 2.0 hosts supplies 5 V at up to 0.5 A (2.5 W). [8] USB 3.0 supplies 5 V at up to 0.9 A (4.5 W) [9]: section 9.2.5.1 Power Budgeting whereas hosts conformant to the USB Battery Charging Specification can deliver up to 1.5 A (7.5 W). [citation needed] As each PoweredUSB plug provides one of three voltages ...

5. USB 3.0 - Wikipedia

   en.wikipedia.org/wiki/USB_3.0

   Under the USB 3.2 specification, released 22 September 2017, [11] existing SuperSpeed certified USB-C 3.1 Gen 1 cables will be able to operate at 10 Gbit/s (up from 5 Gbit/s), and SuperSpeed+ certified USB-C 3.1 Gen 2 cables will be able to operate at 20 Gbit/s (up from 10 Gbit/s). The increase in bandwidth is a result of multi-lane operation ...

6. Switched-mode power supply - Wikipedia

   en.wikipedia.org/wiki/Switched-mode_power_supply

   One of the two switches must be active (e.g., a transistor), while the other can be a diode. Sometimes, the topology can be changed simply by re-labeling the connections. A 12 V input, 5 V output buck converter can be converted to a 7 V input, −5 V output buck–boost by grounding the output and taking the output from the ground pin.

7. Quick Charge - Wikipedia

   en.wikipedia.org/wiki/Quick_Charge

   Quick Charge is a proprietary technology that can charge battery-powered devices, primarily mobile phones, at power levels exceeding the 7.5 watts (5 volts at 1.5 amps) supported by the USB BC 1.2 standard, using existing USB cables. The higher voltage available allows more power (watts) to be supplied through wires without excessive heating.

8. Multiplexer - Wikipedia

   en.wikipedia.org/wiki/Multiplexer

   An electronic multiplexer can be considered as a multiple-input, single-output switch, and a demultiplexer as a single-input, multiple-output switch. [3] The schematic symbol for a multiplexer is an isosceles trapezoid with the longer parallel side containing the input pins and the short parallel side containing the output pin. [4]

9. USB hub - Wikipedia

   en.wikipedia.org/wiki/USB_hub

   USB 3.1, released in July 2013, is the successor standard that replaces the USB 3.0 standard. USB 3.1 preserves the existing SuperSpeed transfer rate, giving it the new label USB 3.1 Gen 1, [7] [8] while defining a new SuperSpeed+ transfer mode, called USB 3.1 Gen 2 [9] which can transfer data at up to 10 Gbit/s over the existing USB-type-A and ...