Search results
Results from the WOW.Com Content Network
Aminosalicylic acid was introduced to clinical use in 1944. It was the second antibiotic found to be effective in the treatment of tuberculosis, after streptomycin.PAS formed part of the standard treatment for tuberculosis prior to the introduction of rifampicin and pyrazinamide.
1,4-Dimethylnaphthalene (1,4DMN) is a plant growth regulator that occurs naturally in potato tubers, preventing them from sprouting. [1] Synthetic forms such as 1-4SIGHT are applied to potatoes during storage. [2] Although discovered in the 1970s, it was not used commercially in the USA until 1996 [3] and in Europe until the 2010s. [4]
Unbranched 1-alkenylsuccinic anhydrides, [9] which can be obtained from 1-alkenes, are solid at room temperature and not suited for engine sizing from aqueous emulsion. [ 10 ] In the SHOP process, even-numbered 1-alkenes (CH 2 =CH-(CH 2 ) n -CH 3 , produced by oligomerization of ethylene) are isomerized on magnesium oxide catalysts with ...
In cases where ICH already has occurred, aspirin use results in higher mortality, with a dose of about 250 mg per day resulting in a relative risk of death within three months after the ICH around 2.5 (95% confidence interval 1.3 to 4.6). [220]
With the exceptions of 1, 8 and 144 (F 1 = F 2, F 6 and F 12) every Fibonacci number has a prime factor that is not a factor of any smaller Fibonacci number (Carmichael's theorem). [56] As a result, 8 and 144 ( F 6 and F 12 ) are the only Fibonacci numbers that are the product of other Fibonacci numbers.
The essential process of the above formula can be summarized in a table; the resulting method is called "tabular integration" [5] and was featured in the film Stand and Deliver (1988). [6] For example, consider the integral
C ratio of 1.12372%. [3] δ 13 C for some sample is then calculated by dividing the amount of 13 C by 1.12372% and then subtracting 1 and multiplying by 1000 to give a value in "per mil". [4] A related standard is the use of a δ 13 C of -25 ‰, corresponding to wood, as the value used in normalization.
The height increases by one for each step away from the back right corner. For example, the corner position (1, 1, 1) has height 1 and ht(2, 1, 1) = 2. The height of an orbit is defined to be the height of any element in the orbit. This notation of the height differs from the notation of Ian G. Macdonald. [10]