Search results
Results from the WOW.Com Content Network
Thrust levers in a Boeing 747 Classic. The center and rear levers are used during flight, while the forward levers control reverse thrust.. Thrust levers or throttle levers are found in the cockpit of aircraft, and are used by the pilot, copilot, flight engineer, or autopilot to control the thrust output of the aircraft's engines, by controlling the fuel flow to those engines. [1]
To increase or decrease overall lift requires that the controls alter the angle of attack for all blades collectively by equal amounts at the same time, resulting in ascent, descent, acceleration and deceleration. A typical helicopter has three flight control inputs: the cyclic stick, the collective lever, and the anti-torque pedals. [2]
The static rollover critical angle can be determined by measuring the angle between level ground and an imaginary line drawn from skid to skid, when the helicopter's center of gravity is located on the upward pivot line. [4] [5] Static rollover also pertains to automobiles. In the study of roll stability of vehicles, the static rollover ...
Cockpit controls and instrument panel of a Cessna 182D Skylane. Generally, the primary cockpit flight controls are arranged as follows: [2] A control yoke (also known as a control column), centre stick or side-stick (the latter two also colloquially known as a control or joystick), governs the aircraft's roll and pitch by moving the ailerons (or activating wing warping on some very early ...
Most commercial aircraft that operate at high flight altitudes are pressurized at a maximum cabin altitude of approximately 8,000 feet. On most pressurized aircraft, if cabin pressurization is lost when the aircraft is flying at an altitude above 4,267 m (14,000 feet), compartments containing the oxygen masks will open automatically, either above or in front of the passenger and crew seats ...
Thrust levers of an A320 set to the autothrust position during cruise flight. An autothrottle (automatic throttle, also known as autothrust, A/T or A/THR) is a system that allows a pilot to control the power setting of an aircraft's engines by specifying a desired flight characteristic, rather than manually controlling the fuel flow.
Aircraft wing leading-edge extensions – annotated. A leading-edge extension (LEX) is a small extension to an aircraft wing surface, forward of the leading edge.The primary reason for adding an extension is to improve the airflow at high angles of attack and low airspeeds, to improve handling and delay the stall.
Especially in England, lever frames with the pivot underneath the floor of the signal box were common. [3]: 122 This design's relatively short lever angle is a major disadvantage, as it requires more force to move the lever. Therefore, later, especially in Germany, lever frames with pivots inside the signaller's room were used, that allow for a ...