enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Fishing rod tapers - Wikipedia

   en.wikipedia.org/wiki/Fishing_rod_tapers

   A rod with a fast taper will only flex the top 20 percent. Medium fast and medium tapers will flex approximately 30 to 60 percent of the rod respectively. If the rod has a slow taper, almost the entire rod or blank will bend or flex under pressure.

3. Tree taper - Wikipedia

   en.wikipedia.org/wiki/Tree_taper

   Tree taper is the degree to which a tree's stem or bole decreases in diameter as a function of height above ground. Within Forestry and for the purposes of timber production, trees with a high degree of taper are said to have poor form, while those with low taper have good form. The opposite is the case for open-grown amenity trees.

4. File:T-S diagram.pdf - Wikipedia

   en.wikipedia.org/wiki/File:T-S_diagram.pdf

   Original file (1,443 × 816 pixels, file size: 66 KB, MIME type: application/pdf) This is a file from the Wikimedia Commons . Information from its description page there is shown below.

5. Skew-T log-P diagram - Wikipedia

   en.wikipedia.org/wiki/Skew-T_log-P_diagram

   The major use for skew-T log-P diagrams is the plotting of radiosonde soundings, which give a vertical profile of the temperature and dew point temperature throughout the troposphere and lower stratosphere. The isopleths on the diagram can then be used to simplify many tedious calculations involved, which were previously performed by hand or ...

6. Thermodynamic diagrams - Wikipedia

   en.wikipedia.org/wiki/Thermodynamic_diagrams

   The P–alpha diagram shows a strong deformation of the grid for atmospheric conditions and is therefore not useful in atmospheric sciences. The three diagrams are constructed from the P–alpha diagram by using appropriate coordinate transformations. Not a thermodynamic diagram in a strict sense, since it does not display the energy–area ...

7. Taper pin - Wikipedia

   en.wikipedia.org/wiki/Taper_pin

   A taper pin is a fastener used in mechanical engineering. They are steel rods with one end having a slightly larger diameter than the other. Metric taper pins have a taper of 1:50. [1] A 1:50 taper means that one end of a 50 mm long bar will be 1 mm smaller in diameter than the other end.

8. File:Original McKelvey Diagram 1976.pdf - Wikipedia

   en.wikipedia.org/wiki/File:Original_McKelvey...

   Date/Time Thumbnail Dimensions User Comment; current: 14:37, 2 September 2021: 725 × 591 (147 KB): Mary Mark Ockerbloom: Uploaded a work by V. E. McKelvey from "Principles of the mineral resource classification system of the U.S. Bureau of Mines and U.S. Geological Survey : Geological Survey Bulletin 1450-A" by Thomas S. Kleppe and V. E. McKelvey, U.S. Bureau of Mines and U.S. Geological Survey.

9. Treemapping - Wikipedia

   en.wikipedia.org/wiki/Treemapping

   Area-based visualizations have existed for decades. For example, mosaic plots (also known as Marimekko diagrams) use rectangular tilings to show joint distributions (i.e., most commonly they are essentially stacked column plots where the columns are of different widths). The main distinguishing feature of a treemap, however, is the recursive ...