enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ATX - Wikipedia

   en.wikipedia.org/wiki/ATX

   An ATX power supply provides a number of peripheral power connectors and (in modern systems) two connectors for the motherboard: an 8-pin (or 4+4-pin) auxiliary connector providing additional power to the CPU and a main 24-pin power supply connector, an extension of the original 20-pin version. 20-pin Molex 39-29-9202 at the motherboard. 20-pin ...

3. Power supply unit (computer) - Wikipedia

   en.wikipedia.org/wiki/Power_supply_unit_(computer)

   ATX motherboard power connector (usually called P1): This is the connector that goes to the motherboard to provide it with power. The connector has 20 or 24 pins. One of the pins belongs to the PS-ON wire (it is usually green). This connector is the largest of all the connectors.

4. Molex connector - Wikipedia

   en.wikipedia.org/wiki/Molex_connector

   AMP Mate-n-Lok and Molex 8981 0.093-inch pin and socket power connectors Molex standard 0.093-inch pin and socket connectors Molex disk drive power connection system tool and connectors Molex Mini-Fit Jr. connector as used for ATX power supply. A Molex connector is a

5. AT (form factor) - Wikipedia

   en.wikipedia.org/wiki/AT_(form_factor)

   Baby AT motherboard An ATX Form Card, used by later Baby-AT motherboards to allow for USB, PS/2 mouse, and IR connectivity through headers. In 1987, the Baby AT form factor was introduced, based on the motherboard found in the IBM PC/XT 286 (5162) [2] and soon after all computer makers abandoned AT for the cheaper and smaller Baby AT form factor, using it for computers that spanned several ...

6. Motherboard form factor - Wikipedia

   en.wikipedia.org/wiki/Motherboard_form_factor

   Derived from the EEB and ATX specifications. This means that SSI CEB motherboards have the same mounting holes and the same IO connector area as ATX motherboards, but SSI EEB motherboards do not. SSI MEB: SSI? 411 × 330 mm (16.2 × 13 in) Created by the Server System Infrastructure (SSI) forum. Derived from the EEB and ATX specifications. microATX

7. Power good signal - Wikipedia

   en.wikipedia.org/wiki/Power_good_signal

   The ATX specification requires that the power-good signal ("PWR_OK") go high no sooner than 100 ms after the power rails have stabilized, and remain high for 16 ms after loss of AC power, and fall (to less than 0.4 V) at least 1 ms before the power rails fall out of specification (to 95% of their nominal value).