Ad
related to: half adder using basic gate control module
Search results
Results from the WOW.Com Content Network
The sum-output from the second half adder is the final sum output of the full adder and the output from the OR gate is the final carry output (). The critical path of a full adder runs through both XOR gates and ends at the sum bit . Assumed that an XOR gate takes 1 delays to complete, the delay imposed by the critical path of a full adder is ...
The control unit decides which operations an ALU should perform (based on the op code being executed) and sets the ALU operation. The D input to the adder–subtractor above would be one such control line from the control unit. The adder–subtractor above could easily be extended to include more functions.
Fig. 1 illustrates the configuration of a half-adder using a crossbar tile, as taught by Snider, with the nodes identifying junctions of the crossbar tile configured as low-resistance states. By setting different logic inputs A, NOT A, B, and NOT B to different row wires this configuration produces the sum and carry outputs typical for a half ...
A conditional sum adder [3] is a recursive structure based on the carry-select adder. In the conditional sum adder, the MUX level chooses between two n/2-bit inputs that are themselves built as conditional-sum adder. The bottom level of the tree consists of pairs of 2-bit adders (1 half adder and 3 full adders) plus 2 single-bit multiplexers.
The number of inputs of the AND-gate is equal to the width of the adder. For a large width, this becomes impractical and leads to additional delays, because the AND-gate has to be built as a tree. A good width is achieved, when the sum-logic has the same depth like the n-input AND-gate and the multiplexer. 4 bit carry-skip adder.
The basic Fredkin gate [3] is a controlled swap gate (CSWAP gate) that maps three inputs (C, I 1, I 2) onto three outputs (C, O 1, O 2). The C input is mapped directly to the C output. If C = 0, no swap is performed; I 1 maps to O 1, and I 2 maps to O 2. Otherwise, the two outputs are swapped so that I 1 maps to O 2, and I 2 maps to O 1. It is ...
The Dadda multiplier is a hardware binary multiplier design invented by computer scientist Luigi Dadda in 1965. [1] It uses a selection of full and half adders to sum the partial products in stages (the Dadda tree or Dadda reduction) until two numbers are left.
For example, the part of an arithmetic logic unit, or ALU, that does mathematical calculations is constructed using combinational logic. Other circuits used in computers, such as half adders , full adders , half subtractors , full subtractors , multiplexers , demultiplexers , encoders and decoders are also made by using combinational logic.
Ad
related to: half adder using basic gate control module