enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Low-noise amplifier - Wikipedia

   en.wikipedia.org/wiki/Low-noise_amplifier

   A low-noise amplifier (LNA) is an electronic component that amplifies a very low-power signal without significantly degrading its signal-to-noise ratio (SNR). Any electronic amplifier will increase the power of both the signal and the noise present at its input, but the amplifier will also introduce some additional noise.

3. Sound World Solutions - Wikipedia

   en.wikipedia.org/wiki/Sound_World_Solutions

   Sound World Solutions’ design platform relies on inexpensive off-the-shelf Bluetooth technology, yielding a hearing device that costs less than a tenth the price of a conventional hearing aid. [7] Rather than disguise its hearing device as a hearing aid, Sound World Solutions designed it to look and function as a Bluetooth device, which is ...

4. Tower Mounted Amplifier - Wikipedia

   en.wikipedia.org/wiki/Tower_Mounted_Amplifier

   A Tower Mounted Amplifier (TMA), or Mast Head Amplifier (MHA), is a low-noise amplifier (LNA) mounted as close as practical to the antenna in mobile masts or base transceiver stations. A TMA reduces the base transceiver station noise figure (NF) and therefore improves its overall sensitivity ; in other words the mobile mast is able to receive ...

5. List of LM-series integrated circuits - Wikipedia

   en.wikipedia.org/wiki/List_of_LM-series...

   Power op-amp with a maximal current output of 3 amperes [23] LM709 Yes General-purpose op-amp [24] LM741 LM709 General-purpose op-amp. [25] Widely used. LM747: Yes General-purpose dual op-amp. [26] LM748 General-purpose op-amp with external compensation [27] LM833 Dual high-speed audio operational amplifiers [28] LM837 Low-noise quadruple op ...

6. Sound reinforcement system - Wikipedia

   en.wikipedia.org/wiki/Sound_reinforcement_system

   Low-frequency signals are sent to amplifiers and then to subwoofers, and middle and high-frequency sounds are typically sent to amplifiers which power full-range speaker cabinets. Using a crossover to separate the sound into low, middle and high frequencies can lead to a "cleaner", clearer sound (see bi-amplification ) than routing all of the ...

7. Bioamplifier - Wikipedia

   en.wikipedia.org/wiki/Bioamplifier

   The amplitude of ECG ranges from 0.3 to 2 mV for the QRS complex, which is used to determine the interbeat interval from which the frequency is derived. The typical requirements for the amplifiers to be used in ECG include: [1] Low internal noise (<2 mV) High Input Impedance (Z in > 10 MΩ) Bandwidth ranging from 0.16–250 Hz

8. The best wireless headphones for seniors in 2025 - AOL

   www.aol.com/lifestyle/best-wireless-headphones...

   Active Noise Canceling (ANC): The hot headphone feature of the 21st century is active noise canceling, otherwise known as ANC. Flip a switch (or press a button) and the earpieces magically reduce ...

9. Valve RF amplifier - Wikipedia

   en.wikipedia.org/wiki/Valve_RF_amplifier

   (This is the reason for the relatively high noise resistance of the EF86 in the above example.) Thus, tubes with low noise at high frequency do not necessarily have low noise in the audio frequency range. For special low-noise audio tubes, the frequency at which 1/f noise takes over is reduced as far as possible, maybe to approximately a ...