Search results
Results from the WOW.Com Content Network
SSFL was used mainly for the development and testing of liquid-propellant rocket engines for the United States space program from 1949 to 2006, [1] nuclear reactors from 1953 to 1980 and the operation of a U.S. government-sponsored liquid metals research center from 1966 to 1998. [3]
The rocket is launched using liquid hydrogen and liquid oxygen cryogenic propellants. Rocket propellant is used as reaction mass ejected from a rocket engine to produce thrust . The energy required can either come from the propellants themselves, as with a chemical rocket , or from an external source, as with ion engines .
Using liquid methane and liquid oxygen as propellants is sometimes called methalox propulsion. [19] Liquid methane has a lower specific impulse than liquid hydrogen, but is easier to store due to its higher boiling point and density, as well as its lack of hydrogen embrittlement. It also leaves less residue in the engines compared to kerosene ...
These cryogenic temperatures vary depending on the propellant, with liquid oxygen existing below −183 °C (−297.4 °F; 90.1 K) and liquid hydrogen below −253 °C (−423.4 °F; 20.1 K). Since one or more of the propellants is in the liquid phase, all cryogenic rocket engines are by definition liquid-propellant rocket engines. [2]
hybrid rocket, liquid rocket engine [45] Commercial space subsidiary of Sierra Nevada Corporation: SpaceDev: Poway, CA United States hybrid rocket: acquired by Sierra Space; used on SpaceShipOne and SpaceShipTwo: SpaceX: Hawthorne, California, United States Merlin / Raptor / Draco / Kestrel: liquid rocket engine
Liquid rocket engines have tankage and pipes to store and transfer propellant, an injector system and one or more combustion chambers with associated nozzles.. Typical liquid propellants have densities roughly similar to water, approximately 0.7 to 1.4 g/cm 3 (0.025 to 0.051 lb/cu in).
The RL10 is a liquid-fuel cryogenic rocket engine built in the United States by Aerojet Rocketdyne that burns cryogenic liquid hydrogen and liquid oxygen propellants. Modern versions produce up to 110 kN (24,729 lb f) of thrust per engine in vacuum. RL10 versions were produced for the Centaur upper stage of the Atlas V and the DCSS of the Delta IV
The J-2, commonly known as Rocketdyne J-2, was a liquid-fuel cryogenic rocket engine used on NASA's Saturn IB and Saturn V launch vehicles. Built in the United States by Rocketdyne, the J-2 burned cryogenic liquid hydrogen (LH 2) and liquid oxygen (LOX) propellants, with each engine producing 1,033.1 kN (232,250 lb f) of thrust in vacuum.