Search results
Results from the WOW.Com Content Network
A baseband signal or lowpass signal is a signal that can include frequencies that are very near zero, by comparison with its highest frequency (for example, a sound waveform can be considered as a baseband signal, whereas a radio signal or any other modulated signal is not). [2] A baseband bandwidth is equal to the highest frequency of a signal ...
Verified for iOS 9.3 and later. 1. Double press the Home button or swipe up and hold. 2. Swipe up on the image of the app. 3. Re-launch the app and attempt to reproduce the issue.
The passband of an FDM channel carrying digital data, modulated by QPSK quadrature phase-shift keying.. The multiple separate information (modulation) signals that are sent over an FDM system, such as the video signals of the television channels that are sent over a cable TV system, are called baseband signals.
Data transmitted may be digital messages originating from a data source, for example a computer or a keyboard. It may also be an analog signal such as a phone call or a video signal, digitized into a bit-stream for example using pulse-code modulation (PCM) or more advanced source coding (analog-to-digital conversion and data compression) schemes.
It may refer more specifically to two subcategories: Passband bandwidth is the difference between the upper and lower cutoff frequencies of, for example, a band-pass filter, a communication channel, or a signal spectrum. Baseband bandwidth is equal to the upper cutoff frequency of a low-pass filter or baseband signal, which includes a zero ...
where =, being the sensitivity of the frequency modulator and being the amplitude of the modulating signal or baseband signal. In this equation, f ( τ ) {\displaystyle f(\tau )\,} is the instantaneous frequency of the oscillator and f Δ {\displaystyle f_{\Delta }\,} is the frequency deviation , which represents the maximum shift away from f c ...
The resulting so called equivalent lowpass signal or equivalent baseband signal is a complex-valued representation of the real-valued modulated physical signal (the so-called passband signal or RF signal). These are the general steps used by the modulator to transmit data:
the line-coded signal can be used to turn on and off a light source in free-space optical communication, most commonly used in an infrared remote control. the line-coded signal can be printed on paper to create a bar code. the line-coded signal can be converted to magnetized spots on a hard drive or tape drive.