Search results
Results from the WOW.Com Content Network
Repeater frequency sets are known as "repeater pairs", and in the ham radio community most follow ad hoc standards for the difference between the two frequencies, commonly called the offset. In the USA two-meter band, the standard offset is 600 kHz (0.6 MHz), but sometimes unusual offsets, referred to as oddball splits, are used. The actual ...
Repeater systems use two different radio frequencies; the mobiles transmit on one frequency, and the repeater station receives those transmission and transmits on a second frequency. Since the repeater must transmit at the same time as the signal is being received, and may even use the same antenna for both transmitting and receiving, frequency ...
RFinder's main service is the World Wide Repeater Directory (WWRD), which is a directory of amateur radio repeaters. RFinder is the official repeater directory of several amateur radio associations. RFinder has listings for several amateur radio modes , including FM , D-STAR , DMR , and ATV .
An extensive digital repeater, or "digipeater" network provides transport for APRS packets on these frequencies. Internet gateway stations (IGates) connect the on-air APRS network to the APRS Internet System (APRS-IS), which serves as a worldwide, high-bandwidth backbone for APRS data. Stations can tap into this stream directly, and a number of ...
In the 1950s negative impedance gain devices were more popular, and a transistorized version called the E6 repeater was the final major type used in the Bell System before the low cost of digital transmission made all voiceband repeaters obsolete. Frequency frogging repeaters were commonplace in frequency-division multiplexing systems from the ...
Additionally, as repeaters are placed on high locations, it also prevents distant stations on the same frequency from interfering. A Morse code or a synthesized voice module may produce station ID to comply with station identification regulations. Large users assigned use of their own frequencies may be exempted from this requirement.
The list of frequency ranges is called a band allocation, which may be set by international agreements, and national regulations. The modes and types of allocations within each frequency band is called a bandplan; it may be determined by regulation, but most typically is set by agreements between amateur radio operators.
Morse code is called the original digital mode. Radio telegraphy, designed for machine-to-machine communication is the direct on / off keying of a continuous wave carrier by Morse code symbols, often called amplitude-shift keying or ASK, may be considered to be an amplitude modulated mode of communications, and is rightfully considered the first digital data mode.