Search results
Results from the WOW.Com Content Network
In this context, high input impedance at the input terminals and low output impedance at the output terminal(s) are particularly useful features of an op amp. The response of the op-amp circuit with its input, output, and feedback circuits to an input is characterized mathematically by a transfer function ; designing an op-amp circuit to have a ...
The actual output impedance for most devices is not the same as the rated output impedance. A power amplifier may have a rated impedance of 8 ohms, but the actual output impedance will vary depending on circuit conditions. The rated output impedance is the impedance into which the amplifier can deliver its maximum amount of power without failing.
where Z dif is the op-amp's input impedance to differential signals, and A OL is the open-loop voltage gain of the op-amp (which varies with frequency), and B is the feedback factor (the fraction of the output signal that returns to the input). [3] [4] In the case of the ideal op-amp, with A OL infinite and Z dif infinite, the input impedance ...
Figure 5: Op-amp differential amplifier. An operational amplifier, or op-amp, is a differential amplifier with very high differential-mode gain, very high input impedance, and low output impedance. An op-amp differential amplifier can be built with predictable and stable gain by applying negative feedback (Figure 5).
This connection forces the op-amp to adjust its output voltage to simply equal the input voltage (V out follows V in so the circuit is named op-amp voltage follower). The impedance of this circuit does not come from any change in voltage, but from the input and output impedances of the op-amp. The input impedance of the op-amp is very high (1 ...
The operational amplifier integrator is an electronic integration circuit. Based on the operational amplifier (op-amp), it performs the mathematical operation of integration with respect to time; that is, its output voltage is proportional to the input voltage integrated over time.
Only the magnitude of the loudspeaker impedance is used, and the power amplifier output impedance is assumed to be totally resistive. Comparison of damping factors for a solid state amplifier (Luxman L-509u) and a tube amplifier (Rogue Atlas) In typical solid state and tube amplifiers, the damping factor varies as a function of frequency.
Three types of OTAs are single-input single-output, differential-input single-output, and differential-input differential-output (a.k.a. fully differential), [1] however this article focuses on differential-input single-output. There may be an additional input for a current to control the amplifier's transconductance.