enow.com Web Search

  1. Ads

    related to: six main interceptor sewage tank pump

Search results

  1. Results from the WOW.Com Content Network
  2. London sewer system - Wikipedia

    en.wikipedia.org/wiki/London_sewer_system

    Construction of the interceptor system required 318 million bricks, 2.7 × 10 6 cubic metres (9.5 × 10 7 cu ft) of excavated earth and 670,000 cubic metres (24,000,000 cu ft) of concrete. [5] The innovative use of Portland cement strengthened the tunnels, which were in good order 150 years later.

  3. Sewage pumping - Wikipedia

    en.wikipedia.org/wiki/Sewage_pumping

    KOS+ M openwell submersible pump. Small-scale sewage pumping is normally done by a submersible pump. This became popular in the early 1960s, when a guide rail system was developed to lift the submersible pump out of the pump station for repair, and ended the dirty and sometimes dangerous task of sending people into the sewage or wet pit. [1]

  4. Effluent sewer - Wikipedia

    en.wikipedia.org/wiki/Effluent_sewer

    Most of the solids are removed by the interceptor tanks, so the treatment plant can be much smaller than a typical plant and any pumping for the supernatant can be simpler without grinders (sometimes water pumps are sufficient). An alternative effluent sewer which is similar to the STEG system is the STEP system.

  5. Pumping station - Wikipedia

    en.wikipedia.org/wiki/Pumping_station

    A four pole or six pole AC induction motor normally drives the pump. Rather than provide large open passages, some pumps, typically smaller sewage pumps, also macerate any solids within the sewage breaking them down into smaller parts which can more easily pass through the impeller. The interior of a sewage pump station is a very dangerous place.

  6. History of water supply and sanitation - Wikipedia

    en.wikipedia.org/wiki/History_of_water_supply...

    In Dubrovnik, then known as Ragusa (Latin name), the Statute of 1272 set out the parameters for the construction of septic tanks and channels for the removal of dirty water. Throughout the 14th and 15th century the sewage system was built, and it is still operational today, with minor changes and repairs done in recent centuries. [65]

  7. Grease trap - Wikipedia

    en.wikipedia.org/wiki/Grease_trap

    Interceptors require a retention time of 30 minutes to allow the fats, oils, grease, and food solids to settle in the tank. As more wastewater enters the tank, the grease-free water is pushed out of the tank. The rotting brown grease inside a grease trap or grease interceptor must be pumped out on a scheduled basis.

  1. Ads

    related to: six main interceptor sewage tank pump