Search results
Results from the WOW.Com Content Network
The company was established as Fabbrica Italiana Carburatori Weber in 1923 when Weber produced carburetors as part of a conversion kit for Fiats. Weber pioneered the use of two-stage twin-barrel carburetors, with two venturis of different sizes (the smaller one for low-speed/rpm running and the larger one optimised for high-speed/rpm use).
Float chamber (left) of an updraught carburettor, showing the float (4) and valve (5). A float chamber is a device for automatically regulating the supply of a liquid to a system. It is most typically found in the carburettor of an internal combustion engine , where it automatically meters the fuel supply to the engine.
A float carburetor uses the venturi effect to supply fuel into the engine intake; this depends upon a constant level of fuel in the float bowl to maintain the desired fuel/air mixture. The float operates a valve which keeps the fuel level in the carburetor consistent despite varying demands by means of a linked float valve. As the fuel level ...
Two-barrel downdraft Holley 2280 carburetor Cross-sectional schematic. A carburetor (also spelled carburettor or carburetter) [1] [2] [3] is a device used by a gasoline internal combustion engine to control and mix air and fuel entering the engine. [4]
DCNF's tend to be either 36 or 40 mm (1.4 or 1.6 in), the larger 44-DCNF is deemed too large for the engine. Both 40-DCOE and 45-DCOE are commonly used where space allows. [5] For a normal street car, a DMTR carburetor is commonly used in sizes varying from 32/32, 32/34 to 34/34.
The float chamber was manufactured as a separate unit and attached to the carburettor by an arm. [12] To mount the carburettor to the engine, the carburettors were available in both flange and spigot options. [13] Four body sizes were available: Type 4 - 21/32", 23/32" & 25/32" bore diameters; Type 5 - 13/16" & 7/8" bore diameters
Of the three types of carburetors used on large, high-performance aircraft engines manufactured in the United States during World War II, the Bendix-Stromberg pressure carburetor was the one most commonly found. The other two carburetor types were manufactured by Chandler Groves (later Holley Carburetor Company) and Chandler Evans Control ...
Carburetor icing is caused by the temperature drop in the carburetor, as an effect of fuel vaporization, and the temperature drop associated with the pressure drop in the venturi. [2] If the temperature drops below freezing, water vapor will freeze onto the throttle valve, and other internal surfaces of the carburetor. The venturi effect can ...