Search results
Results from the WOW.Com Content Network
Fuel tank capacity: 96 L (25.4 US gal; 21.1 imp gal) 82 L (21.7 US gal; 18.0 imp gal) Valvetrain: DOHC, duplex chain SOHC, duplex chain Cooling: Water Gearbox: 4-speed or 5-speed manual or 4-speed automatic rear wheel drive, standard axle ratio 3.69:1 or 3.92:1 (5-speed) 4-speed manual or 3-speed automatic rear wheel drive
When a solar water heating and hot-water central heating system are used together, solar heat will either be concentrated in a pre-heating tank that feeds into the tank heated by the central heating, or the solar heat exchanger will replace the lower heating element and the upper element will remain to provide for supplemental heat. However ...
A trap primer automatically injects water into a trap, maintaining a water seal to keep sewer gas out of buildings. It must be installed in an easily accessible place for adjustment, replacement, and repair. A trap primer, a specialized valve, is usually connected to a clean-water supply in addition to a DWV system. [20]
It is the ratio between the volume of the cylinder, when the piston is at the bottom of its stroke, and the volume when the piston is at the top of its stroke. The bore/stroke ratio is the ratio of the diameter of the piston, or "bore", to the length of travel within the cylinder, or "stroke". If this is around 1 the engine is said to be "square".
It consists of the tank and a septic drain field. Waste water enters the tank where solids can settle and scum floats. Anaerobic digestion occurs on the settled solids, reducing the volume of solids. The water released by the system is normally absorbed by the drain field without needing any further treatment.
Since air is plentiful at the surface of the earth, the oxidizer is typically atmospheric oxygen, which has the advantage of not being stored within the vehicle. This increases the power-to-weight and power-to-volume ratios. Other materials are used for special purposes, often to increase power output or to allow operation under water or in space.
According to a report published by the Water Footprint organization in 2010, a single kilogram of beef requires 15 thousand litres (3.3 × 10 ^ 3 imp gal; 4.0 × 10 ^ 3 US gal) of water; however, the authors also make clear that this is a global average and circumstantial factors determine the amount of water used in beef production.
Sometimes more expensive underground tanks are used for storage. Smaller quantities (say 700 cubic metres (180,000 US gal) and less) may be stored in horizontal or vertical, vacuum-jacketed, pressure vessels. These tanks may be at pressures anywhere from less than 50 to over 1,700 kPa (7.3–246.6 psi).