enow.com Web Search

  1. Ads

    related to: swr power meter 1000 watts portable

Search results

  1. Results from the WOW.Com Content Network
  2. Antenna analyzer - Wikipedia

    en.wikipedia.org/wiki/Antenna_analyzer

    The SWR meter requires a transmitter or signal generator to provide a few watts power test signal. An antenna bridge is able to measure at low power, but also requires a supplied test signal; depending on the bridge circuit, it can be used to measure both reactance and resistance by reading values marked on knobs that have been adjusted for a ...

  3. SWR meter - Wikipedia

    en.wikipedia.org/wiki/SWR_meter

    An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).

  4. Standing wave ratio - Wikipedia

    en.wikipedia.org/wiki/Standing_wave_ratio

    The power standing wave ratio (PSWR) is defined as the square of the VSWR, [3] however, this deprecated term has no direct physical relation to power actually involved in transmission. SWR is usually measured using a dedicated instrument called an SWR meter.

  5. Slotted line - Wikipedia

    en.wikipedia.org/wiki/Slotted_line

    Figure 1. Waveguide slotted line. Slotted lines are used for microwave measurements and consist of a movable probe inserted into a slot in a transmission line.They are used in conjunction with a microwave power source and usually, in keeping with their low-cost application, a low cost Schottky diode detector and VSWR meter rather than an expensive microwave power meter.

  6. Effective radiated power - Wikipedia

    en.wikipedia.org/wiki/Effective_radiated_power

    It is the total power in watts that would have to be radiated by a half-wave dipole antenna to give the same radiation intensity (signal strength or power flux density in watts per square meter) as the actual source antenna at a distant receiver located in the direction of the antenna's strongest beam . ERP measures the combination of the power ...

  7. Field strength meter - Wikipedia

    en.wikipedia.org/wiki/Field_strength_meter

    When measuring with a field strength meter it is important to use a calibrated antenna such as the standard antenna supplied with the meter. For precision measurements the antenna must be at a standard height. A value of standard height frequently employed for VHF and UHF measurements is 10 metres (33 ft).

  1. Ads

    related to: swr power meter 1000 watts portable