Ads
related to: woodworking cross cutting
Search results
Results from the WOW.Com Content Network
The cutting edge of each tooth is angled in an alternating pattern. This design allows each tooth to act like a knife edge and slice through the wood in contrast to a rip saw, which tears along the grain, acting like a miniature chisel. Some crosscut saws use special teeth, called rakers, designed to clean out the cut strips of wood from the ...
The cross-cut saw can cut in any direction but is much slower than needs be when cutting with the grain. [citation needed] The development of saws was also affected by several factors. The first was the importance of wood to a society, the development of steel and other saw-making technologies, and the type of power available.
It is a rough tool that can be used for cross-cutting branches or firewood, up to a log diameter of half the blade length, limited by the height of the frame above the blade. Bow saws are typically available with blades of 320mm, 535mm, 610mm, 750mm or 950mm lengths (14, 21, 24, 30 or 36 inches).
A motorized miter saw. A miter saw or mitre saw is a saw used to make accurate crosscuts and miters in a workpiece by positioning a mounted blade onto a board. A miter saw in its earliest form was composed of a back saw in a miter box, but in modern implementation consists of a powered circular saw that can be positioned at a variety of angles and lowered onto a board positioned against a ...
A type of flat, tapered, single-cut file used to cut, flatten, and smooth (or "float") wood surfaces by abrasion, e.g. when making a wooden plane. Unlike rasps and files, floats have parallel teeth and can be resharpened as many times as the thickness of the blade will allow. flute 1. A deep channel cut in wood. 2. The cannel of a gouge. foxing
The cut of the file refers to how fine its teeth are. They are defined as (from roughest to smoothest): rough, middle, bastard, second cut, smooth, and dead smooth. A single-cut file has one set of parallel teeth while a cross-cut or double-cut file has a second set of cuts forming diamond shaped cutting surfaces. [1]
Ads
related to: woodworking cross cutting