Search results
Results from the WOW.Com Content Network
The MBR bootstrap code loads and runs (a boot loader- or operating system-dependent) volume boot record code that is located at the beginning of the "active" partition. The volume boot record will fit within a 512-byte sector, but it is safe for the MBR code to load additional sectors to accommodate boot loaders longer than one sector, provided ...
The first sector of Track0 is known as the master boot record (MBR) and contains the initial code used to boot the operating system (bootstrap code). Near the end of the MBR is the Partition Table: a predefined structure containing the layout of the disk.
This is why it is easy to replace the usual bootstrap code found in an MBR with more complex loaders, even large multi-functional boot managers (programs stored elsewhere on the device which can run without an operating system), allowing users a number of choices in what occurs next. With this kind of freedom, abuse often occurs in the form of ...
The boot code in the VBR can assume that the BIOS has set up its data structures and interrupts and initialized the hardware. The code should not assume more than 32 KB of memory to be present for fail-safe operation; [1] if it needs more memory it should query INT 12h for it, since other pre-boot code (such as f.e. BIOS extension overlays, encryption systems, or remote bootstrap loaders) may ...
In the case of a hard disk, this is referred to as the Master Boot Record (MBR). The conventional MBR code checks the MBR's partition table for a partition set as bootable [nb 5] (the one with active flag set). If an active partition is found, the MBR code loads the boot sector code from that partition, known as Volume Boot Record (VBR), and ...
The first stage bootloader, which is a part of the MBR, is a 512-byte image containing the vendor-specific program code and a partition table. [6] As mentioned earlier in the introduction part, the first stage bootloader will find and load the second stage bootloader. [6] It does this by searching in the partition table for an active partition. [6]
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
The partition type (or partition ID) in a partition's entry in the partition table inside a master boot record (MBR) is a byte value intended to specify the file system the partition contains or to flag special access methods used to access these partitions (e.g. special CHS mappings, LBA access, logical mapped geometries, special driver access, hidden partitions, secured or encrypted file ...