Search results
Results from the WOW.Com Content Network
The GM AAM axle tubes exhibit a smaller diameter at the spindle compared to the AAM Dodge axles—measuring 4" for GM and 3.5" for Dodge from the housing. In design variation, newer GM trucks are aligned with Dodge axles. Additionally, GM incorporates a vibration damper on the yoke, while Dodge positions it on the drive shaft.
GM began making 4x4 Chevrolet Kodiaks and GMC Topkicks that utilize a Dana 70 front axle for the 2005-2009 models. These Dana 70 axles had open knuckles and ball joints . The Dana 70 axle only came with 5.13:1, 4.88,5.31 [ citation needed ] gear ratios and had a GAWR of [ citation needed ] these axles were rated at 7-9klbs as seen on 5500 door ...
The General Motors Automatic Safety Transmission (AST) was a semi-automatic transmission released in 1937. The first mass-produced fully-automatic transmission developed for passenger automobile use was the GM Hydra-Matic introduced in the autumn of 1939 as a (very likely subsidized) $57 option for the 1940 Oldsmobile. [1]
The GM 9.25 IFS has been the main front differential in Four-wheel drive 3/4 Ton and 1 Ton GM trucks since 1988. The Dana 60 solid axle front end was used selectively in trucks with a higher GVWR from 1988 to 1991. The original Saginaw 9.5 differential, ring and pinion were modified to work with the independent front suspension.
Total face width is the actual dimension of a gear blank including the portion that exceeds the effective face width, or as in double helical gears where the total face width includes any distance or gap separating right hand and left hand helices. For a cylindrical gear, effective face width is the portion that contacts the mating teeth.
The second overdrive is with ring 2 braked which will cause sun 2 to spin faster than in the first overdrive gear. There is one reverse gear. Ring 1 and ring 3 are braked with the input only connected to sun 1. Sun 1 will drive ring 2 in the forward direction and with carrier 2 braked, sun 2 and sun 3 will spin in reverse.
The Dana/Spicer Model 80 is an automotive axle manufactured by Dana Holding Corporation and has been used in OEM heavy duty applications by Chevrolet, Dodge, and Ford.It can be identified by its straight axle tubes, 10 bolt asymmetrical cover, and a "80" cast into the housing.
The Ford–GM 10-speed automatic transmission is part of a joint venture between Ford Motor Company and General Motors to design and engineer two transmissions: a longitudinal 10-speed transmission and a transverse 9-speed trans-axle. Each company manufactures its own unique version of the transmissions in its own factories.