Ads
related to: water line flush valve- Zurn Flush Valve Parts
Common & Hard-To-Find Repair
Parts For All Zurn Flush Valves
- Zurn Bedpan Washers
Manual & Sensor-Operated Zurn
Bedpan Flush Valves & Diverters
- Flush Valve Troubleshoot
Troubleshoot & Maintenance Guides
& Breakdowns For Zurn Flush Valves
- Zurn Flush Valves
Manual, Sensor-Operated, & Water-
Conserving Flush Valves & Retrofits
- Zurn Flush Valve Parts
Search results
Results from the WOW.Com Content Network
The valve is shut off at both its top and bottom positions. A second valve, placed within the main cylinder valve, releases the water in the topmost pressure chamber when the flush lever is activated, sending the main cylinder valve shooting upwards. The topmost pressure chamber slowly refills through its narrow passageway, pushing the valve ...
A vacuum breaker is a device that prevents water from being siphoned backward in a direction it is not desired to go. They are commonly placed on a bibcock valve or toilet or urinal flush valve, in which application they can prevent hose or drainage water from back-siphoning into the public drinking water system. This prevents contamination ...
As the tank water level drops, the float descends and actuates the fill valve. Water is fed to the tank to replenish its supply, and a smaller flow is directed into the overflow tube to refill the bowl. Once the flapper valve closes, the water flow from the fill valve continues until the tank level again reaches the fill line.
After flushing, the flapper valve in the water tank closes or the flush valve shuts; water lines and valves connected to the water supply refill the toilet tank and bowl. Then the toilet is again ready for use. If the forward ("flush") jet connection to the upper inlet in the toilet clogs, poor or no flushing action may result. [citation needed]
Each fixture usually has a characteristic means of connection. Normal plumbing practice is to install a valve on each water supply line before the fixture, and this is most commonly termed a stop or "service valve". The water supply to some fixtures is cold water only (such as water closets and urinals). Most fixtures also have a hot water supply.
The company was founded by William Elvis Sloan in Chicago, Illinois in 1906 with the introduction of the Royal flushometer, a valve to release a measured amount of water to flush a urinal or toilet. Initial sales were very poor: only a single Royal model flushometer was sold in 1906, and two in 1907.
Ads
related to: water line flush valve