Search results
Results from the WOW.Com Content Network
The pascal (symbol: Pa) is the unit of pressure in the International System of Units (SI). It is also used to quantify internal pressure, stress, Young's modulus, and ultimate tensile strength. The unit, named after Blaise Pascal, is an SI coherent derived unit defined as one newton per square metre (N/m 2). [1]
This is a tabulated listing of the orders of magnitude in relation to pressure expressed in pascals. psi values, prefixed with + and -, denote values relative to Earth's sea level standard atmospheric pressure (psig); otherwise, psia is assumed.
The conversion between different SI units for one and the same physical quantity is always through a power of ten. This is why the SI (and metric systems more generally) are called decimal systems of measurement units. [10] The grouping formed by a prefix symbol attached to a unit symbol (e.g. ' km ', ' cm ') constitutes a new inseparable unit ...
Acoustic impedance, denoted Z and measured in Pa·m −3 ·s in SI units, is defined by [2] = ^ ^ (), where ^ is the Laplace transform of sound pressure, [citation needed] ^ is the Laplace transform of sound volume flow rate.
As the pascal is a very small unit relative to industrial pressures, the kilopascal is commonly used. 1000 kPa ≈ 145 lbf/in 2. Approximate conversions (rounded to some arbitrary number of digits, except when denoted by "≡") are shown in the following table.
Some of these derive from a unit of force divided by a unit of area; the SI unit of pressure, the pascal (Pa), for example, is one newton per square metre (N/m 2); similarly, the pound-force per square inch (psi, symbol lbf/in 2) is the traditional unit of pressure in the imperial and US customary systems.
Metric units are units based on the metre, gram or second and decimal (power of ten) multiples or sub-multiples of these. According to Schadow and McDonald, [1] metric units, in general, are those units "defined 'in the spirit' of the metric system, that emerged in late 18th century France and was rapidly adopted by scientists and engineers.
Valid results within the quoted ranges from most equations are included in the table for comparison. A conversion factor is included into the original first coefficients of the equations to provide the pressure in pascals (CR2: 5.006, SMI: -0.875). Ref. SMI uses temperature scale ITS-48.