Ads
related to: sweetwater tube amp vs solid state rectifier replacement
Search results
Results from the WOW.Com Content Network
Tube sound (or valve sound) is the characteristic sound associated with a vacuum tube amplifier (valve amplifier in British English), a vacuum tube-based audio amplifier. [1] At first, the concept of tube sound did not exist, because practically all electronic amplification of audio signals was done with vacuum tubes and other comparable ...
AC/DC equipment would connect all the tube heaters in series to match the supply voltage; a rectifier would convert AC to the direct current required for operation. When connected to a DC supply, the rectifier stage of the power supply performed no active function. DC-only equipment would only run from a DC supply and included no rectifier stage.
The first amp in Ampeg’s Portaflex series was the B-15, a 2-channel tube amplifier with per-channel volume controls and shared Baxandall-type tone control, housed within a ’flip-top’ tuned-port cabinet design mounted to a dolly. Shortly after the B-15’s introduction in 1960, it became the most popular bass amp in the world.
A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.
The term solid-state became popular at the beginning of the semiconductor era in the 1960s to distinguish this new technology. A semiconductor device works by controlling an electric current consisting of electrons or holes moving within a solid crystalline piece of semiconducting material such as silicon, while the thermionic vacuum tubes it replaced worked by controlling a current of ...
The FM-5 tuner was offered as was the SCA-80 integrated amplifier in the early 1970s time line. Dynaco's solid-state kits were different from the popular Heathkit products (and Dynaco's own vacuum tube kits) because of their preassembled circuit boards. These boards were wired at the factory, tested and packaged with the unassembled chassis.
A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...
A hybrid amplifier involves one of two combinations of tube and solid-state amplification. It may have a tube power amp fed by a solid-state pre-amp circuit, as in most of the original MusicMan amplifiers. Alternatively, a tube preamplifier can feed a solid-state output stage, as in models from Kustom, Hartke, SWR, and Vox. This approach ...
Ads
related to: sweetwater tube amp vs solid state rectifier replacement