Search results
Results from the WOW.Com Content Network
A steam generator on a ship is an auxiliary boiler which draws high-pressure superheated steam from the vessel's propulsion system [1] to generate low pressure saturated steam. This secondary steam is then used to power auxiliary shipboard engines driving winches or pumps, or to meet any steam requirement that does not require superheating ...
A steam generator is a form of low water-content boiler, similar to a flash steam boiler. The usual construction is as a spiral coil of water-tube , arranged as a single, or monotube , coil. Circulation is once-through and pumped under pressure, as a forced-circulation boiler . [ 1 ]
Steam generator (auxiliary boiler), a steam-powered boiler used on ships to produce a low-pressure steam, heated by a high-pressure steam supply rather than a flame. Steam generator (boiler), an oil- or gas-fired boiler, based on a low-water content monotube coil. Steam generator (nuclear power), a heat exchanger in a pressurized water nuclear ...
A 60 kW generator set fueled by waste motor oil [44] Chuk Williams' steam-powered land speed record car, [6] [45] followed by a land speed record car built by Cyclone Power Technologies [46] A speed boat designed to break the steam-powered water speed record. [12] A multi-fuel engine to provide hydraulic power to forklift trucks [47]
Unlike the superheater, the steam drier does not attempt to raise the temperature of the steam significantly beyond the boiling point. Steam generator Steam separator Suction valve an automatic non-return valve, which opens when the boiler is at less than atmospheric pressure. This avoids any risk of vacuum collapse, when a hot boiler is ...
The engine room is usually located near the bottom, at the rear or aft end of the vessel, and comprises few compartments. This design maximizes the cargo carrying capacity of the vessel and situates the prime mover close to the propeller, minimizing equipment cost and problems posed from long shaft lines.
The inverted U-tube bundle of a Combustion Engineering steam generator. A steam generator (aka nuclear steam raising plant ('NSRP')) is a heat exchanger used to convert water into steam from heat produced in a nuclear reactor core. It is used in pressurized water reactors (PWRs), between the primary and secondary coolant loops.
The Reactor Protection System (RPS) is a system, computerized in later BWR models, that is designed to automatically, rapidly, and completely shut down and make safe the Nuclear Steam Supply System (NSSS – the reactor pressure vessel, pumps, and water/steam piping within the containment) if some event occurs that could result in the reactor entering an unsafe operating condition.