Search results
Results from the WOW.Com Content Network
The instruction cycle (also known as the fetch–decode–execute cycle, or simply the fetch–execute cycle) is the cycle that the central processing unit (CPU) follows from boot-up until the computer has shut down in order to process instructions. It is composed of three main stages: the fetch stage, the decode stage, and the execute stage.
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
In computer systems programming, an interrupt handler, also known as an interrupt service routine or ISR, is a special block of code associated with a specific interrupt condition. Interrupt handlers are initiated by hardware interrupts, software interrupt instructions, or software exceptions , and are used for implementing device drivers or ...
The instruction cycle (also known as the fetch–decode–execute cycle, or simply the fetch-execute cycle) is the cycle that the central processing unit (CPU) follows from boot-up until the computer has shut down in order to process instructions. It is composed of three main stages: the fetch stage, the decode stage, and the execute stage.
In interrupt-driven processors, this instruction halts the CPU until an external interrupt is received. On most architectures, executing such an instruction allows the processor to significantly reduce its power usage and heat output, which is why it is commonly used instead of busy waiting for sleeping and idling.
The only way to clear the effects of an STP instruction is to toggle RESB. On the Zilog Z80, executing DI (disable interrupts) followed by HALT (wait for an interrupt) results in the CPU staying frozen indefinitely, waiting for an interrupt that cannot happen. However, the non-maskable interrupt signal can be used to break out of this state ...
The first machine to use out-of-order execution was the CDC 6600 (1964), designed by James E. Thornton, which uses a scoreboard to avoid conflicts. It permits an instruction to execute if its source operand (read) registers aren't to be written to by any unexecuted earlier instruction (true dependency) and the destination (write) register not be a register used by any unexecuted earlier ...
Despite interrupt requests (IRQ) having been disabled prior to the WAI instruction, the MPU will respond to any hardware interrupt while waiting. Upon receipt of an IRQ, the MPU will "awaken" in one clock cycle and resume execution at the instruction immediately following WAI.