Search results
Results from the WOW.Com Content Network
Closed-loop geothermal systems (also known as “advanced geothermal systems” or “AGS”) are a type of engineered geothermal energy system containing subsurface working fluid that is heated in a hot rock reservoir without direct contact with rock pores and fractures.: [1] [2] [3] Instead, the subsurface working fluid stays inside a closed loop of deeply buried pipes that conduct Earth’s ...
DX system being drilled in the 1980s. A direct exchange (DX) geothermal heat pump is a type of ground source heat pump in which refrigerant circulates through copper tubing placed in the ground unlike other ground source heat pumps where refrigerant is restricted to the heat pump itself with a secondary loop in the ground filled with a mixture of water and anti-freeze.
The direct exchange geothermal heat pump (DX) is the oldest type of geothermal heat pump technology where the refrigerant itself is passed through the ground loop. Developed during the 1980s, this approach faced issues with the refrigerant and oil management system, especially after the ban of CFC refrigerants in 1989 and DX systems now are ...
There are three configurations, a closed loop design, an open 'fresh air' system or a combination: Closed loop system: Air from inside the home or structure is blown through a U-shaped loop of typically 30 to 150 m (98 to 492 ft) of tube(s) where it is moderated to near earth temperature before returning to be distributed via ductwork ...
Single-home systems can be "vertical loop field" systems with bore holes 50–400 feet (15–120 m) deep or, [16] if adequate land is available for extensive trenches, a "horizontal loop field" is installed approximately six feet subsurface. As the fluid circulates underground it absorbs heat from the ground and, on its return, the warmed fluid ...
A measure of the amount of heat absorption required to melt I ton of ice in 24 hours. A ton of refrigeration is a measure of the amount of cooling delivered by a heat pump (or other air conditioning system). One ton of refrigeration is equivalent to a cooling rate of 12,000 Btu per hour.
The COP of absorption chillers can be improved by adding a second or third stage. Double and triple effect chillers are significantly more efficient than single effect chillers, and can surpass a COP of 1. They require higher pressure and higher temperature steam, but this is still a relatively small 10 pounds of steam per hour per ton of cooling.
The first geothermal area to be exploited for commercial electricity generation was The Geysers, a complex of 22 geothermal power stations located in Sonoma and Lake counties of California, which was commissioned in September 1960. [1]